2003 mustang v6 auto. Started fine but shifter locked in park, no brake lights. Loose connector on brake switch, reconnected. Lights and shifter work now but won't start. Cranks but no go. Tried both keys. Disconnected battery for 1 hour hoping for a PATS reset, no luck. Still cranks but no start.
SOURCE: 95 F150 wont crank
the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.
SOURCE: 2005 V6 Mustang
check for fuel, spark and compression. these are the only things needed for a engine to run
SOURCE: 1969 ford mustang mach 1 brake / stop light switch challenge
I installed a new turn signal switch in the steering column, and it fixed my brake light problem. Evidentally the turn signal and brake light wires use the same plug wires. It cost about $70. I would suggest doing this.
SOURCE: No Brake Lights, unable to switch from park to drive
It is not the multifunction switch. The power feed goes thru the brake switch before the multi function. You have no power the the brake switch because your shift interlock is not allowing you to shift it. I'll look up the wiring diagram and repost with a solution.
SOURCE: 2004 mustang v6 auto won't always shift out of park
no adjustments just need to replace the cable more than likely
212 views
Usually answered in minutes!
×