At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Low fuel light and other stay on when i start my van
When I start my van the low fuel light, the abs light and, the traction control light all stay on and the rpm and speedometer don't work my van runs good any solutions
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Today, most new vehicles come with either an ABS or a traction control system. A problem in the ABS or traction control system is usually indicated by a warning light. When the ABS warning light is on, it means that the ABS has been shut down because of a mechanical or electrical failure.
Is the battery , battery cables , and connections all good ? The ABS and the traction control lights being on wouldn't have anything to do with not starting . The check engine light should be on with the key in the on position , should stay on till the engine is cranked over . The battery is under the rear seat .
The light being on means the system has detected a problem in one or more sensors. The vibration is the ABS modulating the brakes to prevent skidding because it has detected a wheel that is locked up. That wheel is most likely the one sensor that is giving you the error.
The 4 wheel drive will stop working, the computer relies on inputs to help your $X$ but as far as I know if its in $X$ the ABS will not work its programmed that way. Check the 4 wheels and make sure your sensors were not cut that usually happens and will light your abs and traction control light on dash.
It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.
The brake light may be on because of low fluid.The traction control is on because the abs light is on.System requires the abs to be actively working for traction control to work.The most common cause of this is a wheel speed sensor which on this vehicle is part of the bearing hub assembly.You will need a scan tool to locate where the fault is in the abs system.
If your ABS light is on as well, have a shop scan it (it requires a special scanner). If it's just your Trac light without ABS, it is most likely a sensor under the hood at fault. If you are getting a check engine light as well, get the codes read!
This happened to me without an ABS light and it was the upstream O2 sensor. The reason it throws the Trac light is because if any components that the traction control uses (ignition, fuel) are affected by a bad sensor, the PCM shuts down traction.
In fact, when I replaced the O2 sensor, a handful of other little issues resolved as well.
If you do have an ABS light on, it could very well be a wheel speed sensor.
×