Where do i find the key code on a porsche 944 (1988). I lost the original and i would like to replace it without replacing the ignition

SOURCE: Porsche 944 Turbo won't go into gear when motor is running.

Hi mate. I'm no Porsche expert but the most common diagnosis would be clutch failure. If you can shift (even some) gears with the engine off then this would be plausible. Before looking at the complete clutch, try the master and/or slave cylinder, it's more likely to be the master. Pop the bonnet and check the level of brake fluid in the reservoir, there is no "clutch fluid", it's just brake fluid. If it's below the minimum line, top it up then see if it engages gear. Get it checked out, but tell the mechanic your theory, he'll soon confirm it if it is.

sickforvws

• 40 Answers
• Posted on Jan 30, 2009

SOURCE: 1985 944 porsche speedometer stop working

There is a gear in the speedo that breaks. This is plastic gear on a metal shaft. The last fix I did was to remove speedo and open it up. I super glued the cracked gear to the shaft because I was unable to find a new one. It worked again with no future problems. I hope this helps.

SOURCE: 1985.5 PORSCHE 944 digital clock (changing time)

There are three buttons, let's call them 1, 2, and 3, from left to right.


Clock
Time setting

A. 12 AM, PM or 24.00 h
With the clock in the time readout mode, keep
button (2) depressed for 4 seconds -12 AM, PM
or 24.00 flashing. After pushing button (1), either
a 12-hour (AM + PM) or a 24-hour setting
program can be selected. If you only want to
change the display mode, push button (3). The
clock then returns to its normal timekeeping
function.

B. Hours
Push button (2) a second time - hour display
flashes. Set hour by pushing button (1). After
pushing button (3)*, the clock returns to the time
readout mode with new hour setting.

C. Minutes
Push button (2) once more - minute display
flashes. Set minute by pushing button (1). Upon
pushing button (3)*, the clock is started -
accurate to within 1 second.

Stop watch function
The stop watch can only be set in motion if the
clock is in its normal timekeeping mode and not
during setting operations.
A. Push button (3) - 00:00 display appears;
B. Push button (1) - stop watch is on;
C. Push button (1) a second time - watch stops.
(Additional times can be added by pushing button
(1) again - stop watch keeps running. Push button
(1) once more to stop timing.)
D. Push button (2) - 00:00 display appears;
E. Push button (3) - normal timekeeping mode.

If button (3) is pushed during operation A and
B, the setting procedure must be restarted
(push button (2)).

Jim Goldsmith

• 2005 Answers
• Posted on Jun 09, 2009

SOURCE: 1094 944 porsche cranks but wont fire. fuel pump

run a fused wire from the positive side of your fuel pump to your "on" side of your ignition switch bypassing the alarm kill switch and, allowing you to drive the car

SOURCE: I need a new key for Porsche Boxster 1997

Only the dealership my friend and it`s going to cost ya.