SOURCE: spark plug gap on 94 civic
Its written on a sticker on the hood (on the inside) it will say .045 or something like that.
SOURCE: How do I change the spark plugs on a BMW 523i
The spark plug change is very straight forward. Basically, you remove the plastic valve cover trim panel, unplug the harness plugs from each of the ignition coils, remove the two nuts securing each coil, pull the coil up. The rubber spark plug connector boot should come up with the coil. You can now remove the spark plugs.
The spark plugs are not gappable. Install them as they come out of the box.
Replace the rubber connector boots at the same time, these wear out and can cause miss-fire problems.
Note that if you find oil in the spark plug wells, the valve cover gaskets must be replaced. Not only does this make a mess, but it deteriorates the boots and also causes miss-fires.
See the DIY article in the Spring 2005 issue of the Bavarian Autosport - Fast Times newsletter (see link below):
http://www.bavauto.com/shop.asp?HC1=0&HTarget=sc_fasttimes.asp&HCY=&HCM=
Contact Bavarian Autosport for the spark plugs and connector boots (and valve cover gaskets) at 800-535-2002, or order online.
SOURCE: 2000 Chevy Silverado 1500 with 5.8 liter gas motor
you may have a bad coils or coil boots in those cylinders, try switching the coils to a good cylinder and see if the codes change to the other cylinders, if they change then replace the coils, the computer see it drawing more cuurent so it thinks its the plug because its not misfiring or completly grounding out.
If you're replacing the spark plugs in your car
engine, you'll need to set the gap before reseating the
spark plug. The gap is the distance electricity arcs between the ground
electrode and center electrode. The gap must be set correctly to ensure
maximum performance. Here's how to set the gap of a spark plug.
1,200 views
Usually answered in minutes!
×