Starter - Removal & installing
To install:
Disengage the solenoid wiring connector, then the battery positive (B+) nut and wire from the starter motor
Remove the 3 starter motorwhere is starter located and how to remove it - e2afde4.jpgle bellhousing mounting bolts
Remove the starter motor from the vehicle
The starter relay is located in the Power Distribution Center (PDC) in
the engine compartment. Refer to the underside of the PDC cover for
starter relay location.
Hope helped with this (remember rated this help) Good luck.
The pics sometimes are totaly generics; other details for remove the starter, is located right below dipstick, you will need a 14mm or
15mm box wrench.
Two bolts are on the left side of the starter
horizontally.
One bolt attachs the battery cable and a clip hols the
solenoid.
Remove and kragen can test the starter. replace and reconnect, half inch or 12mm socket needed to disconnect the positive cable on the starter.
15mm shallow socket needed for the upper bolt on the starter, a wrench,
preferably a 15mm socket wrench for the lower bolt on the starter.
There is a metal gasket on the starter, don't lose or damage it when
you remove the old starter, you will need it for the new one, easier to
insert it first before inserting the starter as opposed to trying to
insert the gasket while it is on the new starter.
Good luck.
×
SOURCE: Replacing the starter on 2001 Dodge Grand Caravan
with most front wheel drives you must remove the passenger tire and reach through to the starter bolt with an extension and if I remember write with a 15 mm socket you can reach through and take out the bolt
SOURCE: 1998 Dodge Caravan 3.0 Liter Sending unit
it is located in the gas tank.It is called fuel pump module which includes fuel pump,sending unit for gauge and strainer.It can also be replaced separately.You have to lower gas tank to access.
SOURCE: I need a 1998 Dodge Grand Caravan serpentine belt diagram.
The belt routing diagram is shown on a decal located on thehorizontal metal support above the radiator and under the hood support rod (passenger's side near the coolant overflow tank).
PT Stanley
SOURCE: heater lights flashing
Turn it on, Put the heater on high. While the heater is on high hold down the rear wiper, rear washer and recycle air buttons (all at the same time) for 5 seconds. It will reset your heater computer.
6,781 views
Usually answered in minutes!
i must have made a mistake in model it is a dodge caravan se se may make a differance because i can't find or see maybe hidden bolts also there is a support brace or bracket from front frame that make one boult in enasscessable those pictures were helpful except a miss bolt. please check for me again thank you mr anderson
is there any other screw,bolt,or clamp on top hiddenback ,side. because the middle bolt is a set pinof sometype when i looked at one at the auto zone i remove the other to bolts and can not put it straight out (can i try to pop it out through that pin hole)?
×