Needed serpentine belt diagram for a 91 ply. voyager 3.3L engine

http://www.2carpros.com/diagrams/plymouth/voyager/1991 Here are the diagrams.

For the 1997 3.0 liter Grand Voyager:

Remove A/C belt. Release tension on serpentine belt by moving the tensioner, then remove the belt. Be sure to note how the belt is routed.

From way back underneath the car look up along the exhaust pipe leading to the rear manifold, you can just see the bolt on the back of the tensioner to the right of the rightmost spark plug boot (looking forward from under the engine). Route a socket (15 mm I think) on a short extension up along the exhaust pipe and shield (make sure it's cold!), you can just get it onto the bolt. Then snake a socket up and connect to the extension, no universal joints needed. There's just enough room to get enough leverage on the bolt to remove it. From then on it's simple.

I replaced my tensioner a few hours ago as above.

http://www.2carpros.com/diagrams/plymouth/voyager/2000

should be located on the front of engine on top of radiator ot hood.

Click on the following direct Link. It has the Serpentine Belt Diagrams that you will need for your specific engine options.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1991/make/plymouth/model/grand_voyager/1991_plymouth_grand_voyager_drive_belt_routing_diagram.htm

Glad to help.

if you purchase your belt from Autozone or NAPA parts stores,the belt routing is on the back of the package

For the 1991 DODGE DYNASTY - V6 3.3L 201ci GAS FI N R , review this informacion:

Belt Routing Diagram
- Multiple Accessory, w/o A.C. (Mfg. After 2/27/91)
- Multiple Accessory, w/A.C. (Mfg. After 2/27/91)
- Multiple Accessory, w/o A.C. (Mfg. Before 2/27/91)
- Multiple Accessory, w/A.C. (Mfg. Before 2/27/91)



Remove the serpentine belt by using a breakover bar, rachet or serpentine belt removal tool with the correct size socket for the pulley mounting bolt. Rotate tensioner arm to release tension. Remove the belt.

Hope helped with this (remember rated this help) Good luck.

should be under the hood,

Find a pic of routing here:

http://www.2carpros.com/forum/1992-dodge-caravan--serpintine-belt-routing-map-vt170348.html

Good Luck

Dean.