My horn quit working on my 93 ford ranger and all i get is a clicking when i push it.

Fuse 6 for cruise control and fuse 8 for horn .

BBB INDUSTRIES online under Technical

http://www.bbbind.com/free_tsb.html

try changing the main relay

If the switch is replaced,then it can be wiring issue or faulty cruise control board.But as the switch is replaced,get the voltage at the switch tested to confirm the switch is actually receiving voltage.If no voltage received at switch power supply wire then ,apply external 12 volt power to the cruise control switch wire and then see if cruise control comes ON.If yes,then you know wiring is issue.
=============

On this case, to troubleshoot this problem, there are solved help links. Click the link directly and refer the details to solve this problem yourself, with help of diagrams: ------

Ford ranger cruise control not working? http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html

-----------

Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------

Horn and cruise control not working on Plymouth Grand Voyager?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------------

Horn and Cruise control quit working on 2003 Jaguar S-Type?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

-------------

Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500

http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------

Cruise control stop working on 1994 Ford ranger?

http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

----------

Cruise control not working?

http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

--------------

1996 Ford Explorer: Cruise Control Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html

----------

These will help.

Thanks.

On these case,to troubleshoot these problem,there are solved help links.Click the link directly and refer the details to solve these problem yourself,with help of diagrams:------
Ford ranger cruise control not working?

http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html

----------- Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------

Horn and cruise control not working on Plymouth Grand Voyager?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------------
Horn and Cruise control quit working on 2003 Jaguar S-Type? http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

-------------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
Cruise control stop working on 1994 Ford ranger? http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

----------
Cruise control not working? http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

--------------
1996 Ford Explorer: Cruise Control Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html
----------
These will help.
Thanks.

Replace battery terminals and/or clean battery posts. Horn and radio don't use as much juice as starting. Sounds like a lack of amperage or electrical pressure to push the starter motor. Also check battery. Needs 12 or more volts and about 600 or more cranking amps.

There should be a pin hole on the same face of the ignightion key. you push a pin that will fit in the hole and push the key in while swithching it backwards. hope this helps it's been a while

To troubleshoot your problem,there are few help links,provided below.Click the link directly and follow the procedure to confirm the fault.So as per that you can continue further in repairing this issue of cruise control not working.
The direct help links are as follows :-----cruise control not working?

http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html
-----------Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------------
Horn and cruise control not working on car?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------
Horn and Cruise control quit working suddenly?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

----------

Cruise control stop working ? http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

---------

ford ranger cruise control not working? http://technoanswers.blogspot.in/2012/02/2005-ford-ranger-cruise-control-not.html

-------------

My Cruise control not working? http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

----------

This troubleshooting help links will help you to confirm the problem.

Thanks.

Tap on the transfer case motor and see if it will engage, sounds like the tranfer case motor may need replaced.