Its a new tank before you fitted the tank it would need flushing. this is a lining they put on the inside to stop contamination, also to make sure its not been used, the same takes are on diesels and petrol engines and you don't want to mix them up so there is a film on the take to say its not used. you will need to flush out the tank. and flush your fuel lines injectors etc. when you bought the take they should of told you about the lining, or there should be a sticker on the tank to flush out before use.
SOURCE: How do you change the oil filter on a Hyundai Accent 1998/99?
CHANGING ENGINE OIL
Be careful not to burn yourself, as the engine oil is hot.
1.
Run the engine until it reaches normal operating temperature.
2.
Stop the engine.
3.
Remove the oil filler cap (on rocker cover) and the drain plug (on the oil pan). Drain the engine oil.
4.
Re-install and tighten the drain plug to the specified torque.
5.
Fill new engine oil through the oil filler.
a.
Cover the generator with a shop towel before pouring the engine oil to ensure that if oil spills, it will not drop on the generator.
b.
Use a funnel to pour in the engine oil.
6.
Install the oil filler cap.
7.
Start and run the engine.
8.
Stop the engine and then check the oil level. Add oil if necessary.
SOURCE: Can not pumb Gas into Hyundai 2001 accent
Try moving the handle in a different position, or don't put the nozzel all the way in. The vent tube could be clogged.
SOURCE: Fuel gauge not working properly Hyundai Accent
The fuel gauge utilizes a voltage stabilizer located on the back of the instrument cluster. if it's faulty it could cause this problem. The other causes are a wire fault (short) between the gauge and the tank sending unit and the sending unit itself being corroded and stuck in the full position (the float assembly that is). One way to quickly isolate (and maybe eliminate) the problem is to get a used cluster from a wrecking yard and swap it out. If it works normally, there you go... if not you will need to access the tank sending unit (this usually, but not always, involves draining and dropping the tank to get to it. Some cars have an access panel in the body over the fuel tank for this purpose... look under the carpeting in the rear of the vehicle) Once you have access disconnect the power wire (usually red or with a red stripe), and with the key on, the gauge should drop to empty. If it doesn't, the problem is not the sending unit. Hope this helps...;-)
SOURCE: how do you remove radio from hyundai accent 1998
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..
SOURCE: i need to locate fuel filter on 2002 hyundai accent
Remove rear seat, there is an acess panel, remove panel, filter is under that. Before removing filter, release fuel pressure by loosening gas cap.
92 views
Usually answered in minutes!
dam... is a water barrier
and YOU are QUITE offensive...!!
How about you CLEAN it up and try it again ...
Then you would stand a SNOW-BALL's chance of getting my HELP...
×