Ignition key won't turn - 2005 Chevrolet Express

1-
My ignition key will not turn to off. I can remove the key, but it stays in the accessory mode. What's the fix?
My ignition key will not turn to off can remove the key but it stays in...

2.
Ignition key is stuck and does not turn Inspection Service & Cost
Ignition key is stuck and does not turn Inspection Service Cost...

3.
Ignition key won turn

if you mean the key won`t turn to start the car you may have a worn key and or ignition switch. try another key to see if its the key. also make sure there is not tension on the ignition by way of the steering wheel being turned in the full left or right turn causing tension on the ignition.

probably need a new ignition lock or your key is wore. ignition locks arn't too bad to change depending on the vehicle.

ignition keylock cylinder broken or could have the wrong ignition key.

Make sure your steering wheel isn't locked. Sometimes a key won't turn until you jiggle the wheel while trying to turn the key.

If the wrong key was inserted it may have bent a tumbler pin,maybe try some wd-40 or similar and work it with the right key,might drop the tumbler back,,if not the whole ign. cylinder will have to be changed

If your steering wheel is locked, turn it a bit away from the locked position. Key should turn now.

Otherwise, you may need to replace the ignition or you have a bad copy of a key.

I have had this happen on my 98 Voyager. Just have a new key cut. This new key will sometimes cure the problem. The older keys get worn out and won't unlock the ignition. Try this before a much more expensive and time consuming change of the ignition.

Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

the key may be worn badly or the ignition needs to be replaced.