SOURCE: Need torque spec for 2000 Cirrus outer tie rod ends
45 Ft-lbs Tie-rod balljoint stud-to-steering knuckle nut, and 55 Ft-lbs Tie-rod (outer)- to- inner jam lock nut
SOURCE: what is the torque specs on the inner tie rods for
use thread lock on the threads and tighten until it stops, then a little more. been doing it that way for years and hundreds of cars with no problem. you will have to get the car aligned after the work is done. to get it close. measure the distance from inside the nut to the end of the thread. and set the new part to the same distance. it will be very close. best of luck.
SOURCE: torque specs for 1998 tercel 1.5L
Main Bearing Cap Torque-42 Ft. Lbs.
Head Bolts Step 1-33 Ft. Lbs. Step 2- Additional 90 Degrees
Rod Bearing Nuts-29 Ft. Lbs.
Hope this helps
SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs
A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.
SOURCE: want to know what the torque specs are for the
2000 gmc jimmy front cv axle nut (36 mm) torque ratings?
116 views
Usually answered in minutes!
×