SOURCE: no reverse after rebuild on 4L60E Transmission from 1995 GMC Sono
There isn't a modulator on this trans as it is electronic
You can have first gear going forwrd but no reverse. It is possible. The low/ reverse clutch isn't needed to go forward.
SOURCE: 1995 Chevy S10. The transmission (4L60E) has been
Imput drum is built incorrectly or bad imput drum. trans assembled correctly, put on trans x and if trans does not operate correctly I will ship you one for $1000 www.TransmissionGarage.com
SOURCE: My 4L60E transmission will not shift into reverse or overdrive.
Needs rebuilt... www.TransmissionGarage.com
SOURCE: I have a 1997 chevy 1500. The Trans (4l60e) is bad i think
Before guessing at transmission problems, check the fluid level (car warmed up, engine running in Park on level ground) and have the PCM scanned for trouble codes FIRST.
Secondly, put a line pressure gauge (or visit a local trans shop) on the pressure test port and go for a drive to verify proper line pressure. Base pressure at idle in P,N,OD should be around 70psi and around 140psi in R. Max line pressure should be at least 190psi at WOT in 1st or 2nd, 225psi is optimum. If base pressure is low, trans or pump is worn out. If max pressure is low, check EPC solenoid. If reverse is slow to engage, and line pressure does not come up to at least 130psi in reverse, replace the boost valve with a Transgo 0.500" boost valve (easy fix in pan).
Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell. It is possible to remedy a fluid problem by removing the checkball from its cage in the case in the rear of the trans may help (must remove valvebody), or adding a high-viscosity additive such as Lucas Transmission additive or other seal restorer product. May also have worn boost valve (can replace in the pan).
Soft shifting, gradual performance degradation: Poor line pressure rise due to leaking boost valve, clogged EPC filter screen, failing EPC solenoid, or worst case: leaky seals throughout. Transgo HD2-C kit fixes first two without removing trans. Seal restorer may fix last problem, but probably R&R. Also try a transmission flush with BG brand products (Firestone stocks it).
No movement in any gear: pump failure, or total loss of fluid. R&R, or refill pan and find the leak. If out of fluid, avoid running the engine until the trans is refilled to avoid pump damage. To check for pump failure, check fluid level with the engine off, then start the engine and recheck fluid level. If level does not go down when engine is running, the pump is broken.
1-2 or 2-3 shift is slow/soft above part throttle: Trans is on its way out. R&R
Good luck and start with checking your transmission fluid level. Thank you for using Fixya
SOURCE: no reverse on automatic transmission.what could be
internal problem. Depends on the trans. I have seen broken parts, blown seals, or fried clutch plates. If it was suddenly gone, then I would expect a break in a part - perhaps a broken weld
67 views
Usually answered in minutes!
×