Where are all Camshaft sensors located on the engine of a 2008 Suzuki XL7 @
There is two sensor one one each head here is a guide to help walk you through the replacement and the location of the sensors in the diagrams below.
https://www.2carpros.com/articles/camshaft-angle-sensor-replacement
SOURCE: camshaft position sensor
This V-6 has a very hard to find/hard to reach CKP - it is directly under the Distributor, about 4 inches below, inwards toward the Transaxle "bell". Almost dead-center in the back of the engine.
Your going to have to take the Air Filter and the air manifold that runs to the engine off. After that, take off the horn assembly to gain very, very limited access to wedge an extended ratchet into the bowels of the engine.
I think the same socket that undid the horn assembly fit the CKP nut. It takes 10 minutes to undo the bolt a couple ratchet clicks at a time, at least 15 to get the thing to wiggle out, probably 15 minutes to unconnect, reconnect, and snap back to the fram the wire harness, and at least another 10 minutes to ratchet the bolt back in click by click.
Now you know why they say shops charge $500 in to do this - I think they must take the entire engine out... Very painstaking job that requires patience and precision... but quite satisfying to finish it yourself.
Good luck and hope this helps,
SOURCE: I have a 2005 Suzuki XL7 tire pressuer sensor that won't go out!
I hate tire pressure monitors, in this case it sounds like you have a bad one. if you take it to the dealer they will be able to tell you which one is bad.
MIKE
SOURCE: suzuki xl7 which side is bank 2 sensor 2
I assume then that this is a v6. Bank one should be the drivers side (I think) . Sensor 1 would be the one before the catalytc convertor and sensor 2 would be the one after it.
SOURCE: location of oxygen sensor on suzuki xl7 2002
there are probably 4 o2 sensors, one below each manifold and 2 behind the catalyitic convertors
2,192 views
Usually answered in minutes!
×