How do you replace the headlight gasket on a 2006 Chrysler Crossfire? I can't find anything on utube.

No. It has auto lamps.all newer vehicles have them. Some you can turn off. You have to have the light switch in the dash. If it is in the turn signal switch/ column. Your out of luck.

Pull the rubber dust cover back you will see the electrical wires going to the bulb you can pull the old connector off from there it is not inside the housing, the bulb is held in by a small spring clip at the back of the bulb socket.

Raise the hood and look at the headlight assembly from the top, you should see a couple of pins to remove and pull them up...the headlight assembly should come out. then just remove the plug and replace the bulb

Last I checked Chrysler had changed it's headlight mounting from external screws to just the two adjusting screws. Looking down from the top, you should be able to see two Torx head screws that are used to adjust the headlight assembly. The remove teh head light assembly you remove those and the assembly should come right out. Both of these screws or adjusters will be 6 to 8 inches long. I hope your not removing this to change the headlight it self. Chrysler has been using the insert bulbs for several generations and to replace the bulb you only have to unlock the collar on the back of the light assembly and pull and then replace the bulb.

The Chrysler Crossfire third brake light is a LED lamp. The lamps can be repaired with warranty. See www.ledfix.com for replacements.

You can replace the headlights on your Crossfire easily by yourself. headlight image by Carbonbrain from Fotolia.com

When a headlight burns out on your Chrysler Crossfire, you do not need to rush to the repair shop to have it replaced. You can access the headlights in your Crossfire from within the engine compartment, allowing you to change the headlight yourself. The Crossfire uses an H7U headlight bulb, which you can find at auto parts retail stores or at a Chrysler dealership.
Difficulty: Easy

1. 1 Open the hood of your Crossfire to gain access to the headlight assemblies. Press down on the tab on top of the light assembly cover. Remove the cover and set it aside.
   
2. 2 Pull the electrical connection free of the bulb socket. Press the spring clamps securing the bulb into the light assembly. Pull the bulb straight out of position.
   
3. 3 Insert the new bulb in the same position. Ensure that the spring clamps secure the bulb. Press the electrical connection into place.
   
4. 4 Replace the light assembly cover and press it into position until it clicks, securing it in place. Repeat the same process on the opposite headlight if required. Close the hood and test the headlight operation.
   

I had to have the dash taken off cleaned out all hoses and replaced the fan....works great now

It should say the tire pressure specs on the side wall of the tire even if they are aftermarket

I think there is a set screw in the side you have to loosen and then unscrew knob