I'm assuming all the door locks work, (lock and unlock). I know it's a silly sounding suggestion but have you tried going to the passenger side and reaching across the vehicle? When you work the handle does it feel like its trying? Is it still spring loaded? Or is it just loose and floppy? The more common reason for a door handle to fail is one of the linkages inside the door panel has broken. Most of the connectors are plastic so they can snap. On a vehicle this new It could be a linkage thats just worked loose. You'll have to strip the whole door card off the inside of the door to hunt out whats going on. It'll probably cost you the skin off at least one knuckle doing this.
SOURCE: Driver's door handle will not open the door
Take it to the buick dealer. As the daughter of a mechanic, it was a call I didn't want to make! The dealer installed two handles for me and painted them to match for under $100.00. Well worth the trip.
SOURCE: driver door handle will not open door 1993 Honda Civic
there is a pin in the door handle might have broke off there are two 10 mm nuts that will release the handle but you have to take the door panels off and remove it any local junk yard should have it or can order it for you
SOURCE: Exterior rear door handle on Honda Accord 2001
To Remove Door Panel on 2001 Honda Accord:
A: To remove the plastic piece with the door lock button and door handle connected to it:
1- Remove the screw in the middle located behind a plastic cover button
2- Push (slide) the whole assembly Forward (toward front of car)
Besides the screw, it is held in place by 3 hooks on the backside that hook into holes in the metal door frame
3- Now unhook handle from small metal bar going through door by pushing (toward door) plastic clip (blue?) off of the bar, then the bar will come out of the clip hole, thus releasing the handle.
4- Depress little grey button /bar (purple painted on it)on elec. connector to seperate connector, thus releasing door lock switch
Now the whole assembly (metal handle, door lock switch, and plastic piece) will come off door panel
B: The door is held on by 2-screws, 7-plastic snaps/plugs, and 1-plastic plug.
The screws are located: bottom of hand hold and the other behind the handle, both covered by little covers that have to be pryed off to access the screws.(hint: the screw with the built in spacer goes behind the handle when you are trying to reinstall)
The 7-plastic snaps: 3 across bottom and 2 on each side. Not visible, they are mounted to the inside of the panel.
The 1-plastic plug is visible at the upper front of the panel and is the same color as the surrounding trim
C: Take off the big plastic triangle piece above the door panel and behind the mirror. Pull/pry off. It has 2 snaps holding it on. one near bottom and one near the front.
D: Light lens prys off from bottom. Unscrew (1/4 turn) the light assembly with bulb still intact from backside of panel
E: Remove the Hand-Hold/window switch assembly:
SOURCE: Honda Odyssey 2005 sliding doors won't open, beep 3 times
If you click once your remote control ,will open just driver side doors.To unlock all of them have to press twice , and then sliders.
316 views
Usually answered in minutes!
×