I have a 2007 suzuki forenza and the engine sensor fuse keeps blowing as soon as I turn the key to on and it won't start ?????

SOURCE: Tire pressure sensor 2007 suzuki forenza

check ALL tire inflation if its within the specified range. your computer wont reset if one is low or above the manufacturers specifications.

SOURCE: engine 1 fuse keeps blowing when you turn the key

Engine 1 fuse powers the computer and some sensors. I had this same problem on a 98 chevy van 3500 and found the wire going to one of the oxygen sensors had shorted out on the heat shield. Inspect the wires going to all of the oxygen sensors. On this van one of the oxygen sensors on the driverside the wire was laying on the heat shield which eventually rubbed through the wire and shorted it out blowing the fuse. Your short could be on a different sensor but check all of the oxygen sensors because the wire runs so close to the sharp heat shield.

Johnny Brown

• 5763 Answers
• Posted on Nov 28, 2009

SOURCE: on my 2007 suzuki forenza the check engine light

no such code on that car, auto zone uses global testing which pulls universal codes, so that code means someting different for the suzuki, need to have it checked by the dealer or a shop that has import software, or post the code # and i can translate it into import code, good luck.

SOURCE: how much isa transmission range sensor for a 2007

Make sure to check for an adjustment,if there is one,before replacing it.

SOURCE: where is the throttle position sensor on a 2007

on a 2006 it is on the throttle body at the throttle plate. There are actually three TPS sensors in this configuration. One attached to the gas pedal. One attached to the throtle body And, one located inside the top of the engine block. The defective TPS sensor is removable with four screws. American Suzuki has to be a pain in the *** by selling it only as part of the entire throttle body.