Check the data link connector fuse first if good then clean the connectors and also check for loose fitting pins on the scanner and the connector if they are good you must now continuity check those wires for breaks most times its just oxidation on the connector or the contacts need to be crimped a little to make it fit tighter but your fuse might be blown
SOURCE: 1998 toyota tacoma P0302 Cylinder 2 Misfire
do a compression test on the engine.if that checks out ok then the problem is either an ignition problem or a bad fuel injector
SOURCE: How do I replace the right rear wheel ABS speed
it should just have 1 bolt holding it in. easy to replace. look at the end of the axle for a 2 wire sensor.
Testimonial: "Good, quick answer. Thank you."
SOURCE: working on a 98 toyota tacoma v6 4wd 3.4l eng. I
Yes,need to make sure crank is at TDC as well
The port is located under the dash on the drivers side. It is located to the right of the steering column. Should be black and pointing downward.
65 views
Usually answered in minutes!
×