Need help replace blower resistor and defroster still will change on come down

SOURCE: 03 Santa Fe blower motor resistor replacement

the part you need to replace is the blower motor resistor assembly it has a screw on each side of it with a plug in th middle and for the most part it is on the passanger under the dash behind a black cover stop by a auto store and take a look at one and then you know what you are looking for and at the same time you can find out how much its going to cost i am only going to guess it somewhere around $15.00 to 25.00 dollars.

SOURCE: Replacing Blower Motor Resistor

1. Disconnect and isolate the battery negative cable.
2. Open the glove box.
3. Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening, then roll the glove box downward.
4. Reach through the glove box opening to access and disconnect the instrument panel wire harness connector for the blower motor resistor from the resistor connector receptacle (Blower Motor Resistor).
5. Reach through the glove box opening to access and disconnect the blower motor pigtail wire connector from the resistor connector receptacle.
6. Remove the two screws that secure the blower motor resistor to the evaporator housing.
7. Remove the blower motor resistor from the evaporator housing.

SOURCE: Blower motor vent selection switch not working

the hvac selector switch in the dash may be the problem.You need to remove the switch and look at the connector on the back of switch,see if there are any burnt wires at the connector or switch.It's all electronic and the switches have been known to burn out on this and other model.

SOURCE: have to change blower motor resistor where is it located

Located behind glovebox. 2 screws and 2 plugs. very simple

SOURCE: help with location and replacing blower motor resistor

depends on what year van..1996-2000,located in engine compartment just above right strut tower at firewall..2001-2007..located behind glove box