Question about Ford Cars & Trucks

4 Answers

96 Ford ranger turns over but won't start. Fuel pump fuses and relays seem to be fine.

Posted by on

  • Robert Wood
    Robert Wood Nov 24, 2019

    Does it have spark ???

×

Ad

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 1,857 Answers

But do you here the fuel pump energize when you turn the key and is there spark if all are good then try spraying gas or injection cleaner into the throttle body if it runs and then dies the idle air control valve or the throttle position sensor are bad check with a meter

Posted on Nov 24, 2019

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,850 Answers

Does it have spark to the plugs ?

Posted on Nov 23, 2019

Ad

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 190 Answers

Crank sensor

Posted on Nov 23, 2019

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check Fuel Filter

Posted on Nov 22, 2019

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Anonymous

SOURCE: i need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram

Hi

go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.

Good luck and I hope this will awnser your question.

Posted on Nov 08, 2008

Anonymous

  • 8 Answers

SOURCE: 2005 ford ranger fuel pump relay gets hot and engine dies

Like Laurie Mack said. It is the inertia switch below the glove box. Here is some funny information. DON'T change the fuel pump first. Interesting fact: I bought the new inertia switch from Ford and the install instructions that came with it said to install the switch in the protected area to the right where the fuses are. It is like Ford knows it was a dumb place to put the inertia switch, but they won't let you know until after you buy a new one. I have read at least 20 other people on here that had the same problem I just had.

Posted on Apr 14, 2009

ronaldo_ross

Ronado Panaligan

  • 1056 Answers

SOURCE: 1994 ford ranger interminant fuel pump problems

Loose connection is the problem. It takes petience to find where it is at. Do some wiggling on wires to see where it is.

Posted on Aug 13, 2009

Yuma Duner

Sean Duval

  • 5 Answers

SOURCE: Intermittent fuel pump engagement when turning key - 2001 Taurus

try cleaning the connector that goes to the fuel pump, sometimes they corrode on inside. If that does not fix, test the wires feeding fuel pump with a multi meter until the condition shows itself again, if voltage drops to zero or very low then wiring problem, if voltage is unchanged with problem and fuel pump is not working and connectors are all clean, try replacement of fuel pump.

Posted on Oct 09, 2009

Linh Thanh

  • 784 Answers

SOURCE: 91 ford ranger...fuel pump will not run pump is good

It won't hurt to jump sire to drive, It is designed to pump all time when the engine is running. The only problem is the pump should not be on if engine is not running since it is designed that way to prevent a fire while pump continues on once engine is stops in a car accident. There is a control device to immobilize the fuel pump, if there is no speed sensor signal from the crankshaft. This needs to be located and fixed.

Posted on Oct 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why want my 93 ford ranger pick up start without pouring gas into the intake fuel pump want come on unless hot wired straight to batt


There is a fuel shut off switch (inertia fuel shut off-opens on impact) in the wiring between the fuel pump relay (in the under-hood fuse/relay box) and the gas tank. It may have opened. I don't know where it is located, it may be behind a kick panel under the dash. You may have to ask someone where it is.

The fuel pump fuse is a 20amp fuse, also in the engine compartment fuse/relay box. This fuse and it's wire is the power feed for the fuel pump relay.

Dec 13, 2015 | Ford Cars & Trucks

1 Answer

96 Ford ranger wont start. Replaced fuel pump and relay is good, what else could be the problem?


A couple things could be wrong. Make sure the ground for the pump wiring is good. If the ground is good, take a test light and make sure you're getting power to the pump. If not, you'll have to check all the fuses and grounds related to the pump. If you do have a good ground and power going to it, the pump is dead.

Feb 16, 2013 | Cars & Trucks

2 Answers

Truck won't start but turns over


start with the simple. the thumping check the starter make sure it in right and bolted down. now change your fuel filter then check fuel presser

Dec 19, 2017 | 2007 Ford Expedition EL XLT

1 Answer

My 89 ford ranger will some times stall and not start back.You can turn key but fuel pump doesn't start but next day it may run fine


I would suspect a bad eec relay. These used to go out commonly, and the eec relay is what powers up the fuel pump relay.

Oct 19, 2011 | 1989 Ford Ranger

1 Answer

Im lookin for the fuel pump fuse in my 2003 ford ranger


Hello,

In your power distribution box in your engine compartment (Ford recommends

disconnecting your battery before servicing fuses / relays in PD BOX )

fuse # 9 - 20 amp mini-fuse for fuel pump relay and RAP module

relay # 5 - is the fuel pump relay in your PD BOX

also , the fuel pump inertia (shut off) switch is in the right front passengers

footwell by the right front kick panel.

Thanks..

Jun 16, 2011 | 2003 Ford Ranger Regular Cab

1 Answer

My 86 ranger won't crank. Seems like fuel pump is broke


Ensure the battery has a full charge, then have someone stand by the fuel tank filler. Turn on the key, listening for the pump to run. If not heard, check for blown fuel pump fuse and/or bad fuel pump relay.

Apr 12, 2011 | 1986 Ford Ranger 2WD

2 Answers

HAVE A 96 FORD RANGER JUST QUIT ON ME WELL I WAS DRIVING CRACKS OVER BUT NOTHING ELSE CHECK FUSES FUEL PUMP IS WORKING SPARK SEEMS TO FINE


You may have a broken timing belt( look through the inspection cover and verify there is no fraying or broken pieces of belt. if you have fuel,spark,and air, the only thing left is timing.

Feb 21, 2011 | 1996 Ford Ranger SuperCab

2 Answers

Where reset switch for fuel pump is located


I know there is not one on the 96 models. I fought a fuiel pump related issue on our 96. There are several sensors that must be working before the fuel pump will run. Start with the crankshaft sensor, then look at the camshaft sensor, finally there is a relay that actually runs the fuel pump. The relay should be under the hood with the fuses.

Dodge dosen't use reset switches on the fuel pump circuit. The only company I know of that does is Ford and Ford companies like Mazda and Jaguar.

Hope helps.

Jun 25, 2010 | 1996 Dodge Caravan

2 Answers

91 ford ranger...fuel pump will not run pump is good


Maybe you need to test the (pcm) power relay, it controls the fuel pump relay. Once the key is turned on the pcm will initialize the power relay, it in turn will turn on the fuel relay for 2 seconds to prime the fuel rail prior to starting. Since the pump runs continuosly, it means the pcm isnt properly grounding the ckt or the relay is faulty.

Oct 14, 2009 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...