SOURCE: Where is the location of the knock sensor for a 2005 HD 2500 6.0
HAS TWO KNOCK SENSORS they are both under intake in valley of engine. remove intake and will see two black grommets they are under those best to replace both at same time
SOURCE: Location of knock sensor on 1994 toyota 22vre engine
The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.
SOURCE: knock sensor 1996 v6 3.3 nissan pathfinder
The Crankshaft Position Sensor is located:
Under hood, driver side, front engine area, mounted rear of crankshaft pulley
The Knock Sensor is located:
Under hood, center, front engine area, below intake manifold, mounted on block
SOURCE: Need to locate knock sensor on 1999 camry V6. Where is located.
i have toyota windom 4vz-fe i need locate knock sensor
SOURCE: i need to know where the egr valve is located
EGR stands for EXHAUST GAS RECIRCULATION.
This is a loop back system between your exhaust manifold and the underside of your filter.
The EGR valve is located between the inlet (exhaust manifold) and the outlet (intake manifold).
About 8-12" below the air filter....toward the passenger side.
EGR carbon built up can be clean.
Check the soft membrane on the EGR valve and see is it crack/torn. If it's in good shape then you may reuse it.
The professional use a vacuum hand tool to determine the travel of the EGR.
There are carbon built up inside the EGR air passage tube too,
Make sure you give both a good cleaning.
The EGR base gasket MUST BE REPLACE!
Order one before you start the job.
Please post more info on the comment window.
128 views
Usually answered in minutes!
×