Question about Ford Cars & Trucks

1 Answer

2005 Ford f 250 6.0 super duty how much should the fuel pressure be at

Posted by on

  • mary robbins
    mary robbins Nov 22, 2019

    The truck won't start so what's the pressure work key on engine off is it the same pressure

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 770 Answers

45 PSI.

Posted on Nov 22, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
emissionwiz

Marvin

  • 85216 Answers

SOURCE: need a wiring diagram for 2006 f-series super duty 250

Ford sells a wiring diagram book, really detailed, about $35

Posted on Dec 11, 2008

MNfisherman

Nate Stansfield

  • 11896 Answers

SOURCE: how many quarts of transmission fluid takes ford

On average it is 8 quarts. You can ask part store and they will also know.

Posted on Sep 09, 2009

motor1258

Mike Butler

  • 6674 Answers

SOURCE: 1999 Ford F-250 Super Duty 6.8 liter v10 is

You'll have to drain system down when cooled off, remove any brackets in your way such as power steering reservoir holding bracket, then remove 2 bolts holding the housing, and remove it. Rad hose should be o.k. to leave on, but if it creates a problem, remove it as well. I'd install a new thermostat and "o" ring complete,then a new gasket as well. Clean all surfaces well before re-installing. Replace any bracket(s) you removed to access housing, after housing is installed. Remember, air valve on edge of thermostat goes in 3 oclock position when re-installed. Also a reminder as well, spring on thermostat goes down when re-installed. After all is re-assembled, re-fill coolant and start engine and run with heater on to bleed out all air. Leave rad cap off and pay attention to temperature gauge and when you see it getting to normal operating temperature, watch flow in rad for increased flow, indicating thermostat opened and coolant is circulating properly. Wait until you see that flow increase 2 or 3 times, and air should be out of system, and top up coolant in rad, put cap back on, and check that return bottle is at proper level as well. Keep an eye for any leaks, and re-check return bottle periodically for first little while, just to be sure all is good. Note: some only use the "O" ring as a seal, and no gasket is required, but just check that at autoparts place where you get part.

Posted on Dec 28, 2009

Aceppdug

  • 75 Answers

SOURCE: WHERE IS THE FUEL FILTER ON 2006 F-250 SUPER DUTY?

it is located on the top of the engine in the center. It is round and has a black top. There will be 2 of them one smaller is an oil filter the larger one is the fuel filter.

Posted on Jan 27, 2010

elivingstone

  • 1 Answer

SOURCE: i need a fuse box diagram for a 05 ford f 250 super duty

my 2005 f250 diesel is all of a sudden not going into 4 x 4, no lights on dash now and cannot engage on wheels manually. Does anyone know where there is a fuse that operates this function that I can check?

Posted on Nov 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Ford F-250 Super Duty trouble code p0270


code p0270 refers to injector 4--circuit low===causes---wiring short to ground---injector ---ECM
replace the injector

Jan 08, 2014 | 2005 Ford F 250 Super Duty

1 Answer

Where isThe fuel reset switch on a 2005 ford F-250 is located


these switches are normally located on the passenger side kick panel of the cab. it'll be slightly under the dashboard. I hope this helps

Dec 26, 2010 | 2005 Ford F 250 Super Duty

1 Answer

Ford suer duty 250 diesel has diesel in water


I think you mean that you have water in your diesel fuel. Open the valve behind the fuel/water separator and drain out some of the watery fuel into a pan (place pan under the car). If you have a lot of water in your fuel, you may need to have a professional drain your fuel tank, flush out the fuel system, and try to salvage the fuel for reuse. I hope this helps.

Aug 29, 2010 | 2005 Ford F 250 Super Duty

1 Answer

I have 2005 f-250 super duty and the display reads "check fuel cap" I hit clear and now it reads "check engine"


the loose fuel cap can cause what the motor calls an emmisions leak, which will cause the check engine light to appear, if you have checked the cap and it is tight and the problem with the lights persist, there could be a vacume leak on the motor causing the same issue, some vehicals see the small vacume leak and just assume it is their fuel cap.

Mar 21, 2010 | 2005 Ford F 250 Super Duty

1 Answer

2006 f250 fuel pressure problems


you might want to check and change both fuel filters. the one on the frame and the one under the hood. You also might want to clean your tank out. I had a problem like this on my 06 and it was trash in the tank.

Apr 22, 2009 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...