SOURCE: Lighting prblem
MY BRAKE LIGHTS DONT WORK. I CHECKED FUSES AND THEY WORK. I CHECKED BULB AND ARE GOOD. WHEN I TURNED MY HEAD LIGHTS THEY WORK BUT WHEN I PUSH THE BRAKE PEDAL THEY DONT.
SOURCE: 1998 chevy truck tail light
Somtimes the bulbs get a dead short in them even though they look OK. Install new bulbs or remove all bulbs on this circuit and reinstall one at a time to see if fuse pops. I had this problem with signal lights on 95 chevy 1500 and turned out the back up bulbs were on the same circuit. Bad back up bulb so once truck was in reverse it blew the fuse and then the signals did not work. Cheap enough to be worth a shot.
SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
SOURCE: my 2003 chevy impala turn signals won't blink
Hi,
Your problem is your blinker or flasher, it is located under dash, behind the instrument panel right above the steering column. Cost is no more than $10.
If helpful, click below, GOOD LUCK
SOURCE: 2003 Chevy S10 Brake lights
OK try this, push and hold brake then push on the hazard switch if brake lights come on then replace the turn signal switch.
38 views
Usually answered in minutes!
×