Question about Saturn Cars & Trucks

1 Answer

Code 327 and336 on my saturn 1998 sl

Will start and run once or twice then stall and wont start up but will if u pop the clunch

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Saturn Master
  • 1,723 Answers

Clunch ? clutch Are those P codes ? P0327 an P0336
The knock sensor is a piezoelectric device that produces an output voltage based on mechanical engine vibration. The PCM will retard the electronic spark timing on the signal being received. The knock sensor produces an AC signal. The amplitude and signal frequency is dependent upon the knock level. During normal operation, the knock sensor system attempts to filter out all engine noise that is not caused by spark knock. The diagnostic test for DTC P0327 turns OFF all filtering during the first 20 seconds of engine run time. If a sufficient amount of noise is detected during the 20 second test, the diagnostic passes. If no noise is detected, the diagnostic fails. Since DTC P0327 is a type B code, the diagnostic must fail during 2 consecutive ignition cycles to set the DTC.
DTC P0336
The crankshaft position (CKP) sensor defines engine position by generating an electrical pulse each time it passes by a notch of the crankshaft reluctor wheel. The PCM uses crankshaft sensor pulses for fuel delivery and spark timing.

Posted on Nov 07, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 8 Answers

SOURCE: car wont start unless i pop start it 1998 sw saturn manuel

Listen under the hood next to fuse box for a cliking sound when ignition is turned. If you do not hear this click you many need a starter relay.

Posted on Dec 09, 2008

motor1258

Mike Butler

  • 6674 Answers

SOURCE: Cam Shaft Position Sensor 1998 Saturn SL

Have a look at this link, scroll to your engine & click on picture to expand for better view.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904

Posted on Jan 23, 2009

Anonymous

  • 186 Answers

SOURCE: solution for 1998 saturn sl

Hello DTC P0341 & P0133 very common saturn Codes.You need to check condition of Plugs & wires,If not New Replace All Plugs & Wires,also I would replace the #1#4 Coil for the P0341.For the P0133 Reaplce your front O2 sensor with an OEM sensor,not an aftermarket.

Posted on May 11, 2009

ddegroote

Dan De Groote

  • 35 Answers

SOURCE: 1993 Saturn SL stalling

First, if the SES light is on or comes on a little after it is running it has a code set in the computer. Itis easy to read the code on an OBD1 system by jumping the A-B terminals on the DLC Data Link, block under the drivers side see the following link for better explanination of reading the codes, http://www.troublecodes.net/GM/
Also review the following on the O2 Sensor and coolent temp sensor http://www.saturnfans.com/forums/showthread.php?t=37884 http://www.youtube.com/watch?v=XQ9vtD_ssjg, good luck you can fix this vehicle easily.

Posted on Jun 01, 2009

wekjo

  • 3911 Answers

SOURCE: fuse box diagram for 1998 saturn sl

There is an interior fuse panel just to the left of the passenger's left knee. The cover It is held on by velcro. After you take off the cover, you will see a diagram on the inside of the cover telling you which fuse is for what. This is covered in your manual, which is in the glovebox. If you do not have a manual you can get one off ebay for a few bucks.

Posted on Jul 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 saturn. car stalls out after you are stopped


This may be the result of bad plugs and or wires. It sounds like a simple tune up would do this car good.

Jan 28, 2010 | 1998 Saturn SL

1 Answer

My car wont start my mechanic put it on machine the codes were P0133 P0341 P1599 P1620 he said i need a computer


ok now for starters, we will go with the most probable:P0341 crank position sensor. chances are it needs to be replaced. 2nd your check engine light has probably been on for a while right?! the P0133 is an o2 sensor code and would probably be good maintenance(but get it to run first. 3rd P1599 refers to it stalling out which if it died while running would most likely trigger this. and last but not least either your coolant level switch is faulty or you really do have low coolant. let me know.

Nov 02, 2009 | 1998 Saturn SL

1 Answer

Speedometer and tach suddenly dop..more like flutter..to zero


must be losing ground on it check body ground

Oct 01, 2009 | 1998 Saturn SL

2 Answers

98 saturn sl runs fine for a week or two, then stalls and wont restart. Sometimes it will start after a few hours, sometimes it wont start for 3-4 weeks. We have replaced the alternator, starter, ignition...


have your battery checked,sometimes when we fix the charging problem we over look the battery.if it was damaged from the alternator being bad and it was not recharged properly then is can be broken inside.you can not see this.a load test on the battery will show this damage.

Aug 03, 2009 | 1998 Saturn SL

4 Answers

98 Saturn SL2 - Stalling issues


I had a problem with starts on my 98 sc2, did it twice only, but it would start up, shake a bit then shut down like it wasn't getting fuel, or a wrong mixture. Replaced the coolant temperature sensor and starts / idles like new now... goodluck

Jun 22, 2009 | 1998 Saturn SL

1 Answer

1993 Saturn SL stalling


First, if the SES light is on or comes on a little after it is running it has a code set in the computer. Itis easy to read the code on an OBD1 system by jumping the A-B terminals on the DLC Data Link, block under the drivers side see the following link for better explanination of reading the codes, http://www.troublecodes.net/GM/
Also review the following on the O2 Sensor and coolent temp sensor http://www.saturnfans.com/forums/showthread.php?t=37884 http://www.youtube.com/watch?v=XQ9vtD_ssjg, good luck you can fix this vehicle easily.

Mar 15, 2009 | 1993 Saturn SL

2 Answers

Car wont start unless i pop start it 1998 sw saturn manuel


The battery may not have been your problem it may be that the altenator is not keeping it charges allowing the battery to run down have it checked most auto parts stores will do it for free

Dec 01, 2008 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...