SOURCE: Buick Regal brakes
28-DEC-08
Sometimes (when changing the brake calipers on disk brakes, or changing wheel cylinders on drum brake systems) the mechanic will clamp a vise grip pliers on the rubber hose to prevent hydraulic fluid from dripping out. This can break the internal fiber lining in the rubber hose. Then the fluid flow can be blocked. When you press the brake pedal, fluid may not flow to the wheel or wheels. As you press harder, the fluid may suddenly flow through the line, causing the brakes to suddenly activate.
Or an even more likely problem, your brakes drag (stay on) and get hot, because the fluid cannot flow back to the master cylinder when you release the brake pedal. In other words, when you press the brake you force fluid through a partially blocked rubber hose. But the return of the fluid (backwards through the rubber hose) is caused not by pressure, but just by equilibrium, a balancing act. Well, if the line (rubber hose) is blocked, the fluid stays in the caliper or wheel cylinder, and the brake is still on, and the brake gets hot.
Ken
Camas, Washington
[email protected]
SOURCE: 1999 Buick regal Security light on. Won't start.
I had the same problem with my 95 Lesabre. The owners manual says to take the key out, and wait 3 minutes(until the light goes off). It should fire right up.
SOURCE: my 1996 buick regal will not start
Yes, I can tell you how to bypass it, but it is easier to just replace the ignition lock cylinder. That is what is bad.
148 views
Usually answered in minutes!
×