We just put new gaskets on our 94 jeep grand cherokee laredo was runing great now something keeps blowing the eng control fuse help!!!

Get yourself a set of factory wiring diagrams,
otherwise your wasting your time

You have no idea what you working on, without
reference material

Helm.Com

check water level in radiator- can be low enough for no heat but engine still not overheat

that depends on what part of the country you live in. here in nys, a 4.0 will cost approx. at a junk yard ) low miles. about 3 to 4 hundred.

COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.

i have a 1997 jeep grand cherekee laredo and am having a problem with the alarm its a factory alarm it whent off and i cant get it to reset i tryed everything i could locking and unlocking the doors i put all new fuses and relays in i even unpluged top dash alarm sensor and body control module and it just dont want to reset and it dont want to run at all how can i take care of the problem

Traced the problem to the Lamp Outage Module located in the rear left quarter access panel behind the spare tire. Arcing had occurred on the left taillight line. Fortunately this part is readily available at your local Jeep recovery yard (none available in the U.S. from dealers). Recommend J& W Auto Wreckers in Antelope, CA (web site available). Massive number of Jeeps and fair prices. If you don't want to replace the LOM then you can join the two connectors that go into the LOM (LOM is optional) but you'll always show a lamp failure on your console.

most likly to be the fan its self, pulling to many amps witch would blow the relays every time???

You might have a wire from the engine control circuit that has rubbed through on the engine block somewhere. Do a visual inspection of the engine wiring, and look closely for any damaged insulation. I have seen a problem like this before. Good Luck!

I have the same model Grand Cherokee Limited 5.2L V8, nice truck; for fuse panel description and locations, check page 7 and next. All the infor that you need is here: Jeep-ZJ-Grand Cherokee-Secc-8W-Wiring-Diagrams.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

I have a 2000 Jeep Grand Cherokee the power windows,power seat , door would not lock , and the inside lights would stay one ..i thought it was a fuse problem but no fuses for that ... in the rubber boot between the door and frame ..the was the ground wire was split ... put a **** connector on it everything works great now ....