Rear blinker on passenger side does not work. The bulb is good. Front blinker works. Blinkers front and rear driver's side work.

There should two separate bulbs for marker and blinker. It sounds like a bulb is burnt out, bad ground, melted socket or a wiring anomaly. Are you certain it's supposed to have 57 series dual element bulbs for blinker and markers?

Not sure I follow your story.
The front and rear turn signal should blink on one side. If the tail lamps are not working, it could be a fuse or a problem with the wiring. And the tail lamps are on the same circuit as the front parking lamps.

Did you use LED replacement bulbs or standard bulbs?

If you used LEDs then THAT'S you problem.

This means that either your front or rear blinker light on your drivers sides is not working. Activate your hazards by pulling up on the knob on your steering column labeled by the orange "hazard" cone insignia.
Then check to see if either the front or the rear driver-side blinker is not working. This one will need to be replaced for both of them to work correctly.

You've got relay problem. Please replace your blinker relay

Sounds like you need bulbs on both rear side lights. Does the blinker flassh really fast?

Check the fuses in the fuse panel area. Check to see that the bulbs are good. Good Luck, Jim

replace the drivers front bulb. There are 2 different elements in the bulb 1 for park lights 1 for directional

Usually a fast turn signal means that there is a light out. You should probably check all of your lights, including back-up lights, and turn signals. If there is one out then replacing the burnt out bulb should fix the problem.

have you checked the wire connections to the fround blinker??? when the wire disconnects from the blinker the back blinker blinks faster and the front one doesnt work at all