Owners manual below, fuse start page 353
I see several fuses which have something to do with transmission or shifting. I see nothing saying TCM but I would check every fuse which might have something to do with transmission control module and 4wd.
https://my.chevrolet.com/content/dam/gmownercenter/gmna/dynamic/manuals/2000/chevrolet/blazer/2000_chevrolet_blazer_owners.pdf
SOURCE: 2002 chevy blazer fuel pump (4 door)
yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate
SOURCE: 1994 chevy s10 blazer 4x4 push button type
small sylinoid on the top of the transfer case needs replaced. easy to do. it has three vacumelines going to it just trun out and replace like a bolt.
SOURCE: 2000 chevy 1500 truck stuck in 4-wheel drive
the shifter accuator or the wires going to it on the transfercase..gl
SOURCE: replace lower ball joints on a 2000 chevy blazer 4
Raise vehicle up on jack stands so that the stands are under the lower controll arms and the suspension is "loaded" Remove the front tire(s) (if you break the torque on the nuts while the wheel is still on the ground it helps, but do not loosen them completely as you will be looking for new rims and wheel studs too). Place a drift or some other suitable object in one of the brake rotor vanes so that it will hit the brake caliper and stop the rotor from moving and remove the CV shaft nut (it's a big ****** make sure you have the right socket on hand before getting to this point). Next remove the brake caliper and rotor then undo the wheel bearing retaining bolts and remove the wheel bearing. This should give you enough room to move the axle shaft back and up so you can work on the ball joint. If you've had ball joints replaced before just unbolt the ones that are installed and using a pickle fork, or a block of wood and a hammer, drive the ball joint stud from the knuckle. (make sure to support the upper control arm so it doesn't drop down on you when you do this) If you are working on original ball joints then I reccomend placing a block of wood or something else that will protect the cv boots from drill bits ect and drill out the rivets holding the ball joint in place. then remove in the same manner indicated in the previous paragraph. installation is pretty much the reverse of removal and don't forget to torque your cv shaft nut I have a 1999 and the manual specs 103FTlbs... This is a critical torque as it helps preload your wheel bearing. Too high and you'll burn them up, too low and they'll be loose and wear out.
Testimonial: "Thank you for your directions this will help very much."
SOURCE: 1996 chevy blazer won't engage in four wheel.
there is small motor at the gear box , chk if its working or replace the assembly from scrapyard
372 views
Usually answered in minutes!
×