Question about Cars & Trucks

Open Question

When I start my 2006 newmar mountain aire .light and buzzer goes off just for about 5 seconds and comes back on and stay on until I put it out of gear.on the dash it say buzzer call

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
pal03246

Phil Lovisek

  • 726 Answers

SOURCE: idle too high +goes higher when put in gear (manual transmision

IAC valve problem. Nissan has a updated harness (with one way diode inside of the harness) to prevent backfeeding for the IAC valve and a new IAC valve also gets installed. That's where I would look. IAC valve or "idle air control" valve.

Posted on Sep 21, 2008

Ad
emissionwiz

Marvin

  • 85216 Answers

SOURCE: Battery light on dash

The battery light is an indication of some kind of problem with the alternator, most likely a diode problem in the rectifier bridge, this changes AC current to DC current to supply power to the car and charge the battery.

The cruise problem is most likely the cruise control module is failing.

If you have more questions please contact me on this same thread.

Posted on Oct 19, 2008

Anonymous

  • 36 Answers

SOURCE: 2003 AUDI Quattro 3.0 check engine light(MIL) stays on

Before you do anything else you are just going to have to read the codes. So buy the maintance book at autozone,locate the little juction box on the fire wall and jump the terminals with a little wire. Then of course sit in the drivers seat turn on the key(do not start) and read the blinks. Then you will know what the problem is.

Posted on May 06, 2009

paul campbell

  • 1071 Answers

SOURCE: air brake buzzer stuck on

may have a small air leak or faulty pressure sensor

Posted on Jul 21, 2009

emissionwiz

Marvin

  • 85216 Answers

SOURCE: door ajar light and buzzer stays on when I'm driving my 2006 ford focus

This problem is caused by one of the door ajar sensing switches being defective, it is a common fault in Many Ford cars and light trucks. Each door has a switch and two at the tail gate door. The switches are attached to the side of the door latch and very hard to replace, since you would most likely have to detrim at least two doors to find the bad switch the most prudent thing to do is have the dealer scan the door ajar waring system, the scan will indicate exactly which switch has the problem.

Posted on Jan 25, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 volvo xc90. low beam headlight comes on. stays on about 10 seconds, flashes on and off 5 seconds, goes off 5 seconds. repeats 3 or 4 times then goes off and stays off. replaced bulb and ballast.


does it have daytime running lights that sensor could be bad or signal light switch ...signal to the opposite side light goes out to see if comes on

Nov 14, 2017 | Volvo Cars & Trucks

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

2 Answers

In my 2006 ford fusion 2.3L whenever I put my key in the ignition and turn it a weird solid ringing sound start and stops 5 seconds later hat could it be?


Not surprisingly, many others have experienced problems with the ignition switch on this car. Historically, it is not a sound, but that the key is stuck in the ignition. http://repairpal.com/key-will-not-come-out-of-ignition-570 Your problem sounds different, but it may be related. Although I do not recommend the fix in the link above, it is possible the previous owner of your car did perform this fix and it has resulted in the problem you now have. My better guess is that the chime/buzzer has failed due to moisture or dirt and is no longer producing the sound that it should, but instead is altered to the ringing you describe.To disable follow these instructions:

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, at a moderate speed, buckle
then unbuckle the safety belt 9 times, ending in the unbuckled state.
(Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.)
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
This will disable the BeltMinder feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.
This will enable the BeltMinder feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.
I hope this helps. Good luck.

Jun 12, 2014 | 2006 Ford Fusion

1 Answer

Had car scanned codes PO601 came up 1x code Po420 came up twice. sum say the ECM going out


code p 0601refers to engine control module (ECM)--memory check--sum error=== causes --ECM
code p 0420 refers to cat converter system bank 1--efficiency below threshold===causes cat converter --wiring --- heated oxygen sensor (HO2S) in exhaust manifold before cat converter
At this point get a known good ECM unit and substitute it for the old one as all indications are a problem ECM unit

Feb 07, 2018 | 2006 Chevrolet Cobalt

1 Answer

Dome light stays on afrter the door is shut And the ''door ajar light comes on And the dome light will not go out. If I take the lamp (bulb) out the door ajar goes out and of couse the light goes out,...


in the door jam there is a switch it sounds like the switch either needs to be adjusted or replaced to adjust loosen the big flat screw at the bottom and turn the switch to acheive the right height. if it is at the correct height then try a new switch. this should solve that problem if not then you have me stumped also.

Nov 14, 2009 | 1999 Ford Ranger SuperCab

1 Answer

5 series' of 5 beeps in a row on start up


Check the Air Bag Indicator Light. When you turn the car on it should stay on for 6 seconds and then turn itself off. If a fault is detected in the system operation check, the indicator light will either fail to light, stay on continuously or flash. The flashing may not start until up to 30 seconds after the initial systems check.

If there is a fault in the system AND the air bag indicator light fails to light then an audible tone will alert you- it will be a set of 5 chimes (bells/beeps) five times in a row.

Have the Air Bag serviced and the indicator light bulb changed. Since the dash will be off in order to change the bulb, I would have all of the other dash lights changed at the same time. If one goes out, others will surely follow.

Good luck!

Corri R. / Service Writer

Jan 26, 2009 | 2002 Mazda Tribute

2 Answers

Tune up Buick 2006


You need to Replace your Cas Cap. The Seal is bd on it and is allowing air into the Fuel Tank Causing Both Dash Lights. This should solve your Problem.

Jan 25, 2009 | 2006 Buick LaCrosse

2 Answers

Break failiure


Well sounds to me like you might have some moisture in the fluid which can cause the breaks to fail. Have your break system flushed totally out and refilled. Brake fluid is very touchy. If you leave brand new brake fluid bottle open for a few days it will draw moisture from the air and ruin the fluid.

Jan 03, 2009 | 2002 Volkswagen Passat

2 Answers

I have a citroen xantia 2.0 hdi,glow plug light goes out to quickly not on long enough,problem still there even after new glow plugs were fitted, would apreciate help thanks.


have you tried the glow plug relay? or if you have a test light see if theres power to glow plugs when light is on,should only light for 5 or so seconds.some of the newer hdi dont even use the glow plugs till temp is very cold,i have a 2006 2.0 hdi van and glow plug light only stays on for a second or so,and its been like that from new! is the problem just bad starting? and is it only when its cold? if you have a manual priming pump for fuel under bonnet,trying pumping before starting it could be fuel prob?ie air getting into fuel system

Nov 02, 2008 | Peugeot 604 Cars & Trucks

1 Answer

Intermittent battery light


replace your alternator" the diodes are going bad

Jun 22, 2008 | 2006 Saturn Vue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...