Clean the grease out of the socket. Also make sure the brass connector is good as to the wire check ur ground to that light
Check to see if wires connected to bulb are getting hot you might have a dry solder or looser connection
Probably not the bulbs. If this is an insertion type bulb, the center contact in the socket may be either corroded or has lost its springyness and is not contacting the bulb properly. Check and clean it and with power off, try to pry it up a bit. If the bulb has contact wires, check for a tight fit and corrosion in the sockets. If that is not the problem, then a solder connection at the back of a socket could be broken.
SOURCE: ROUGH IDLE
You have rust particles in the float bowl. The easiest thing to do is remove the side cover of the carb (the thing that unbolts, with a sight-glass on it) and spray carb cleaner into the float bowl until it is clean.
SOURCE: !998 jeep Cherokee-no reverse lights...left turn signal
Replace turn signal switch on colum probubly emergrncy and turn combo check your back up switch on man transmission. if auto transmission check selector switch on linkage.
SOURCE: Saab '02 9-3 "electrical"problem
Most likely it is the ABS module is going bad and needs to be replaced or rebuilt at www.bba-reman.com, hope this helps.
SOURCE: I have a 2004 ford focus. The battery light came
you should a button on right side of dash which opens boot
SOURCE: 2003 Toyota Corolla oil pressure light flickers
see if you have any oil level or pressure sensors. sometimes these can get gunked up. You may need a new oil pump. I suggest you start using a senthetic oil (valvoline,mobil 1 is reccomended) after u get the problem fixed.
53 views
Usually answered in minutes!
×