TORQUE VALUE FOR VALVE COVER FOR 2004 4.7L DODGE

The torque specification for the cylinder valve cover stud/bolt on a 2007 Honda Accord 2.4L VTi is 7.2-8.1 lb-ft (10-11 Nm).
As for replacing the broken stud, it depends on how the broken stud is located and the extent of the damage. If the broken stud is easy to access, it may be a simple matter of unscrewing the old one and putting a new one in with the correct torque specification. However, if the broken stud is difficult to access or if it has caused damage to the threads, it may require a more complex repair. In some cases, it may be necessary to drill out the old stud and tap new threads or to use a helicoil insert to repair the damaged threads.
It's important to note that over-tightening the valve cover bolts/studs can lead to damage or deformation of the valve cover or gasket, and under-tightening can lead to oil leaks. So, it's crucial to torque the bolts/studs to the specified torque value.

Hi Matthew,,
this is all i could find,try this link might help you.
Whats the torque specs on valve cover bolts on 1999 dodge dakota sport 3...

Torque spec's for what hardware on the 2013 Dodge Dart Rally 1.4 Turbo? Headbolts? Main bearing caps? Rod bearing caps? Camshaft drive hardware? Valve covers? Oil pan? What?

you dont torque a valve cover,hand tight or you crush the gasket

Here's a link on your valve covers. Repair Guides Engine Mechanical Components Valve Covers AutoZone com Here's another link Matt on relieving the fuel pressure. Repair Guides Relieving Fuel System Pressure 2 4l 3 3l 3 8l Engines...

Welcome to FixYa.com What engine do you have?
Thank you for Using FixYa.com Kind Regards, Lee Your FixYa Expert and Master Technician

Torque valve cover 17ft.lbs

TORQUE ON VALVE COVERS ARE NOT THAT MUCH. GO ONLINE FOR RESEARCH. IF YOU WANT A GENERAL ANSWER, TIGHTEN TO SEAT CAP OVER GASKET, THEN NO MORE THAN ANOTHER QUARTER TURN ON EACH BOLT. DO NOT "CRANK" IT DOWN AS YOU WILL SPLAY THE GASKET AND CAUSE OIL LEAKS.

15 foot pounds... no pattern is given for such a low torque value

Felpro brand gaskets are the best in the world, not sure about the intake, if it is in the way then yes remove it.