2005 suzuki reno high engine speed

SOURCE: 2005 F150 Engine Noise

Had the exact same problem on my 05' f-150. changed belt tensioner pulley and the belt since I have 78000 on truck. I've put 3500 miles on since and its resolved the problem.

SOURCE: check engine light comes on and goes off then comes back on n a few days

When mine did that, i needed a full tune up done.

SOURCE: Have a 2005 Jeep Liberty. After starting from a

The flashing light indicates you have a big misfire that could damage the catalytic converter.. Being you were going uphill (under high load) this would indicate an ignition issue. You may have a bad coil or wires or a bad spark plug. The reason you could only go 30mph was because the computer was put in limp mode. This is a stratagy to prevent excessive damage to components. , Get it checked out ASAP

SOURCE: 2005 suzuki reno, how do you reset check engine

leave the battery disconnected for a while, 20 min to make sure it resets the computer. If the light is still on then there in an ongoing fault that is getting tripped and turning on the check engine light. Go to an autozone or local autoparts store, they will check it and erase it for you for free.....OBDII scanners aren't cheap.

Testimonial: "thanks"

SOURCE: 07 suzuki reno engine light is on,what does that

The " check engine light" is also known as a malfunction indicator light (MIL). You can disconnect the battery red lead for about 5 min and it will reset. However, if there is a hard fault, it will come back on.

Pull the codes from the computer using an OBD (II) code reader. Match the code to the troubleshooting procedure, follow the procedure to find the source of the fault. After you have repaired the fault, the light will go out if that was the only problem. There are "monitors" or self tests the computer runs the car through a drive cycle, if a problem occurs, it may not run all of the self tests until that problem is taken care. Therefore, another problem may exist.