Take down and check he bearing if is the same as the old one or if is put in rite
Hi Zandre Are you sure you have put the Clutch centre plate in the correct way round?
Some plates its impossible to fit incorrectly as you would not be able to fit the pressure plate. However some you can fit incorrectly, its been a long time since I have fitted a clutch to a 98 Nissan so I cannot remember if it is possible to make this mistake.
Did you have this issue before fitting the clutch if not then its something you have done.
If you did then I would be looking at possible bent or fractured clutch pedal brackets or linkages. Good luck.
SOURCE: vibration shudder at around 30km
Hey Pontiac,
There are two things, firstly get your front wheel rims put on a lathe machine to check for distortion, if not, then get the wheels balanced on a digital tyre balancer.
let me know if this works
SOURCE: VW Clutch Adjustment polo 2001 Hydrolic or Cable?
This is a hydraulic clutch you can't adjust is.
SOURCE: clutch
be careful with the pedal adjustment. aside from the bleeding the hydraulic clutch should "set itself". also the clutch booster might be having issues.
SOURCE: 98 nissan terrano, just fitted new clutch kit, and
are you sure u bled the clutch properly ? cant be any air in the line ! check fluid level in master cylinder and pull guts out of slave cylinder 2 make sure there are no leaks ( splits in the rubber ) other than that ur clutch fork may not be on the thrust bearing correctly !!!
SOURCE: clutch pedal goes to floor and stays 1999 Nissan
ON A 2000 MAX 6 CYLINDER HAS CLUTCH MASTER CYLINDER AND SLAVE CYLINDER, CHECK FLUID LEVEL AND BLEED CLUTCH SYSTEM AT SLAVE CYLINDER BLEEDER. HAVE NOT HEAR OF CABLE CLUTCH SYSTEM. ONLY HYDO.& LINKAGE. GOOD LUCK
268 views
Usually answered in minutes!
×