My 2003 honda crv right front lock is not working and needs to be replaced, How do I remove the current lock?

https://www.youtube.com/watch?v=sgzldlc_3kc . You can find the original manufacturer's horns for the Honda CR-V by raising the hood and looking at the front. There should be one horn on each side of the license plate behind the bumper.

https://techinfo.honda.com/rjanisis/pubs/om/tk0707/TK0707O00397A.PDF

Electronic Chassis Control Module remote door lock module located in the drivers door. Black about the size of a pack of cigarettes.

defective door lock actuator for 03 honda crv, consult your nearest car accessory installer for actuator replacement. now consider your problem solve.

edwin

You will need to take the car to a deal and verify you are the rightful owner of the radio as this is the purpose of the code.
Best of it. While at the dealer why not ask about any recalls on your car?

if the noise only occurs at full lock then it is the pump clutch slipping which is normal.sounds awful but okay.

your tranny

the little motor that operates it inside the door is probably frozen, so it will need to be replaced!!

check to see if the rubber bushing is on the master cylinder pushrod where it bolts up to the booster..if its missing and or doubles , it may cause u to lock ur brakes up..i had this problem where the tech didnt put one and or didnt remove one while installing the new master cylinders...there should only be one. most factory and aftermarket mast cyl come with one however techs sometimes for get to check the booster for the old one some assume its still there cuz they always almost get stuck in there..so they install the new master cyl.without one or with one and either they have none..or both...it only needs one...

You need to take this in and have the body control module scanned for proper function.