SOURCE: 2000 dodge ram 1500 on a 4:10 differential witch transsmition use
I got the info on page from a dodge ram parts seller but I forgot the enet address sorry, any ways thanks a lot.
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: growling coming from front differential
There's not really a best way. If the axle half shafts bolt to the housing just drop it right out. If not you'll have to remove both half shafts from the wheel hub. Disconnect the drive shaft, and drop it out.
SOURCE: I need to remove the front axle out of the
when removing the front axle i believe that you must open the front differential cover and inside the dana you will see a small 8mm bolt located on the spider gear center it holds the pin bar in place and the pin bar holds both the upper and lower gears in place with a small washer below them. be careful when you pull the pin bar out to make sure the gears stay in place (upper and lower) do not let the washer fall out of the spider cage assembly. Then, carefully slide the U pin that holds the axle in (there are two of them one for the left axle and one for the right). Once the U pin slides off the axle the axle should slide all the way out of the whole differential - Note if the U pin you see at the end of the axle does not come off easy just push the axle IN ward towards the center of the differential and then slide it out with a small screw driver ..
97 views
Usually answered in minutes!
×