SOURCE: 04 Dodge SRT 4 crankshaft sensor
The Crankshaft Position Sensor is located directly next to the starter.
Reverse Order to install except note that:
Use a twisting motion when installing the sensor.
Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).
SOURCE: Crankshaft position sensor location - 1991 Dodge Dakota 5.2L
it is on the passenger side on the back off the motor.there are two allen head bolts or 13mm.it goes into the transmission and normally has rubber at the opening.you should be able to gets this from the top follow middle of valve cover on pass. side the go strait back toward the fire wall.please rate this answer.
SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE
Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: 2002 dodge stratus crankshaft sensor location?
The crankshaft or the shankcraft as we refer to it is inside the engine, it turns over the pistons. Never heard of such an animal. You may have a fuel pump going out, clogged fuel filter, fuel injectors, Idle air control valve going out, bad plugs, plug wires or distributors. Just began checking them one at a time.
642 views
Usually answered in minutes!
×