SOURCE: REPLACE FORD TAURUS WAGON DRIVER SIDE MIRROR
you have to take the door panels off. remove all screws you will have plastic pieces called christmas trees that hold the panel in place. there is a tool for this you can pick it up at Napa for cheap this will allow you access to the inner space of the door un plug plugs to power switchs and the rod to your door catch hardeware you then can remove panel completely to get access to mirror assembly. installation of door panel is in reverse
SOURCE: cant remove the headlight assembly from a 1998
You have to basically remove the bumper cover in order to do this.
You will need a 10mm socket with a couple extensions and a phillips screwdriver.
First remove the plastic shield inside the wheel well using the phillips screwdriver.
There are 3 10mm bolts that have to be removed the attach the bumper cover to the fender. The first one is just inside the newly uncovered hole. For the other 2 you will need the extensions. They are located all the way back in the hole beside the headlight assembly. If you look in with a flashlight You will see 3 bolts down in there. One of them will have a 1/2 inch spacer on it. Do not worry about this bolt, it holds the header panel on. The other 2 bolts are the ones you need to remove. Once this is done, if you need to remove the bolts under the hood that hold the bumper cover on the header panel. You should now have adequate movement to move the bumper cover out of the way of the 3 10mm bolts on the headlight assembly that were blocked.
SOURCE: Broken headlight assembly
Remove the upper bolt
Then the 3 lower ones. Then this assembly should slide out.
SOURCE: Need to replace headlight assembly on 2005 Ford Escape
ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..
Item
Part Number
Description
1
—
Headlamp assembly bolts (3 required)
2
—
Headlamp assembly nut
3
13008
Headlamp assembly
4
14290
Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
SOURCE: Passenger side mirror replacement procedures
If its a power mirror there is more thing you will have to remove to get to the wires but if not there is a screw on the corner piece on the inside of the door. just pull the screw out and the bolts (3) that hold the mirror on are behind it. If it power then you will have to remove the door panel to access the wiring to disconnect it
54 views
Usually answered in minutes!
×