How much would it cost to have a front seal replaced on a 2002 L200 Saturn

SOURCE: The brake lights on my 2002 Saturn L200 do not

Check your brake light switch, it could be faulty.

SOURCE: 2002 SATURN L200

Had the same thing happen on my '02 Saturn L200 a few years ago. The brights would come on every now and then when using the turn signal, but after a while they would stay on and the turn signal/headlight switch handle would flop around. After taking it apart, it turned out the plastic on the inside was broken. The switch was relatively inexpensive (<$50) from the dealership and easy to install for the somewhat mechanically inclined.

SOURCE: speakers replacement for 2001 saturn L200

try crutchfield.com

SOURCE: looking for air pump relay location for saturn

As per the Haynes manual for your vehicle:
The various relays are mounted in several locations throughout the vehicle, although many key relays are located in the fuse/relay blocks under the intrument panal and the engine compartment.
Hope this helps!

Jeffrey Turcotte

• 8991 Answers
• Posted on Dec 20, 2010

SOURCE: L200 Saturn 2002. Where is the blower fan located

It's in the engine compartment. See removal instructions below from autozone.com.

1. Select the following settings:
   
   Turn the ignition ON Select Recirc in the OFF setting Turn the ignition OFF
   
2. Disconnect the negative battery cable.
3. Remove the wiper arm assemblies.
   CAUTION A sharp edge is revealed once the weatherstrip is removed.
   
4. Remove the weatherstrip at rear of the engine compartment.
5. Remove the cowl retaining nuts.
   
   

1. Remove the cowl screen assembly.
2. Rotate the locking tabs outward to release the filter assembly.
3. Remove the filter by lifting straight up.

1. Remove the wiper module retaining bolts.
2. Reposition the wiper module to the right.
3. Remove the filter housing attachment bolts.
4. Remove the filter housing.
5. Remove the blower motor housing:
6. Remove the blower motor housing screws

1. Release the locking tabs and remove the fan housing
2. Disconnect the blower motor electrical connector.
3. Squeeze the bottom of the connector and pull downward.
4. Remove the blower motor assembly by lifting straight out.