SOURCE: immobiliser
hi check the fuses in the vechicle and if there ok you would have to see if there is a positive feed at the immobiliser as they are delicate circiuts you may have burned them out best of luck yates210456
SOURCE: IMMOBILISER
The key has a micro chip in it that transmits a signal/code to the anti-theft module/immobilizer. There have been cases where the immobiler/module has forgotten wht code it should respond to or the chip in the key has gone bad. Either way the vehicle will have to go to the dealer for repair as they will have to reprogram the immobilizer for the new key and vice versa depending on which of the 2 items went bad. Hope this helps u
SOURCE: 2001 daewoo lanos immobiliser problem car wont
Radio code has no bearing on the immobiliser at all.
Normally it is down to the key not recognised. Are you using the same / usual key as before? If not then try original or another key as it may be the transponder in the key you are using.
If same key or no joy then remove the lower Black plastic steering cowls on the column (normally 3 or 4 screws) you will expose the barrell assy, on the end of this you'll see the transponder pick up ring. Disconnect from loom, apply silicone grease to pins and reconnect then try starting.
If still no joy, disconnect positive terminal off the battery, touch the lead to an earth point for 2 to 3 seconds to defuse and reset ECU, reconnect and try again.
If still noy joy you will need a garage as special reading equipment is required.
Regards
Lloyd
SOURCE: how do i fix immobiliser on a 02 peugeot 206cc
There is a chip in the key fob, might need reprogramming by Peugeot! Try your spare key.
Testimonial: "i have tried the second key and it is the same"
115 views
Usually answered in minutes!
×