Probably but I would ask the dealer. They didn’t change those vehicles much over the years.
It should, but take the 2009 transmission control module with it just in case there were any changes internally.
SOURCE: auxilary power, electric windows, cigarette lighter and radio not working
Since all fuses are okay, I would start my trace from the fuse box and pick the easiest wire to trace which would probably be the lighter or aux. Check for any breaks in the line or any lose connections. It seems like a harness may be disconnected or cut.
SOURCE: Replace horn on 2006 crown vic
I believe once you have mounted the horn and connected the wire you will find that the horn wire was cut at (by) the steering coloum that the siren override was hooked to,you will have reconnect this,I hope this helps you
SOURCE: 97 Crown Vic transmission issue
Check the transmission linkage cable that runs from the steering column under the dash to the trans under the car. make sure that the cable is not damaged and that all connections are tight.
SOURCE: 2008 crown/vic police,feul guage reads empty,have
I have an 01 P71 interceptor. Had the same problem. The float in the tank was stuck towards the bottom. I ran it low on fuel, and it stayed there.
SOURCE: 92 crown vic - temperature guage on the dash is not working...
The temperature gauge sending unit is located in the front section of the intake manifold, just to the right of the alternator on the 4.6L engines. Got this from autozones repair manuals
124 views
Usually answered in minutes!
×