Put fuse back in
Okay i did now light back on car wont start and radio wont turn on along with cig lighter but all lights on help??? Car has been sitting for 2 weeks now
is the security light on? is the battery fully charge?
Brand new battery and yes light is on cant get it off tired the turn key 10 mins then off 3 times
Try This
Close all doors.
Insert key into and remove it from ignition key cylinder six times within 10 seconds.
(Hazard warning lamps will then flash twice.)
NOTE
-Withdraw key completely from ignition key cylinder each time.
-IF procedure is performed too fast, system will not enter registration mode.
Insert key into ignition cylinder and turn to ACC position.
Push any button on key fob once.(Hazard warning lamps will then flash twice.)
At this time, the oldest ID code is erased and the new ID code is entered.
×
SOURCE: 92 Nissan Pathfinder brake lights stuck on
Change the brake light switch on the brake pedal arm. Go down to the parts store and ask for a new brake liight switch for your Pathfinder and look up under the dash where the brake pedal arm goes and you will see the switch. You will need to unplug the wires to your old one and disconnect it and install the new one the same way. It is pretty much self adjusting once the brake pedal is released. If the brake light does not go out adjust the switch pin to be longer so it will depress when the pedal is released
SOURCE: '01 Nissan Xterra won't turn over starter, after trying to start the headlights flash.
starter possibly going bad
SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA
I just changed out a tailight on my 2000 Nissan Xterra, so I assume it may be similar. You have to pop the plastic strip which runs across the back. There are pop rivits in it.
SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA
thode screws hold the lens or the light assembly? Allow for the whole tail light to come out and the bulb plug will be accessible. I never had the privilage. But how the lens fits will tell you. If the lens goes overthe edges, the whole unit comes out, lens is sealed. Good luck
SOURCE: change brake light on 2006 Xterra
After you remove the 2 bolts there is 2 cone shaped tensioners that help hold the taillight housing on. Grab the taillight firmly on the top and bottom, and pull it straight towards you until the tensioners pop. They will not be damaged and are made to pop in and out.
Then find the bulb housing of the burnt bulb, turn the housing clockwise, and remove the bulb housing, remove the bulb by pulling on the black base of the bulb only on the short sides on the housing. (DO NOT pull on the glass, as it may break in your hand). Then slide the replacement bulb into the housing (it can go in either direction), and repeat the steps in reverse order. to put the housing and taillight back on.
Be careful to tighten the taillight bolts by hand only, they have a plastic thread sleeve that is easily stripped by a drill.
200 views
Usually answered in minutes!
×