Question about Jeep Grand Cherokee

Open Question

I have a 1997 cherokee laredo that locked itself and is no in a security mode. The 2 keys we have will not unlock the doors Can we bypass the security mode and have it run I just bought this jeep.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

mfoxfire

  • 120 Answers

SOURCE: CAN YOU TELL ME HOW TO USE A SLIM JIM TO UNLOCK JEEP GRAND CHEROKEE LAREDO. LOCKED KEYS IN CAR.

a slim jim is not a good ideal to be using in todays cars and trucks with airbags everywhere and wires inside doors..call a pro and if he pulls out a slim jim send him packin...there a re far better tools to use than a slim jim

Posted on Oct 25, 2008

Ad
emissionwiz

Marvin

  • 85222 Answers

SOURCE: alarm sounding upon unlocking door with key

there is a sensor that tells the anti theft module you used the key to unlock the door, it is attached to the door latch or lock cylinder, u must have disconnected the wire to the sensor, so it thinks u are breaking into the car.

Posted on Feb 11, 2009

Robert Debison

  • 412 Answers

SOURCE: 2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly

you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired

Posted on May 17, 2009

Anonymous

  • 1 Answer

SOURCE: 2001 Jeep Grand Cherokee Laredo. Alarm sets off

I found a solution on another site showing if i turn the ignition on and hold the reset button on behind the alarm light untill it turns to solid blue light then turn off the ignition , it will disable the alarm.

Posted on Dec 13, 2009

davidfink327

David Fink

  • 140 Answers

SOURCE: 1996 Jeep Grand Cherokee - Will Not Start or Run

they have crankshaft sencers on the transmission on jeeps. it would be up high on the drivers side on front of transmission. they will cause it to not get fuel or fire and can run then quit.

Posted on Sep 21, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 jeep anti theft will not stay running


your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

Jun 05, 2015 | 2000 Jeep Grand Cherokee Laredo

1 Answer

1997 Jeep Grand Cherokee. Alarm keeps going off and disabling car. Have tried passenger door and turning key towards hood and still no success. Will alarm reset itself in "X" hours. Suggestions...


I had to repeat the unlock and lock a few times to each lock ... but what I found out was my 2 back passenger doors were NOT locking so be sure they all are locked before going around with your key... hope this helps... I have had no problems since

Jul 10, 2011 | 1997 Jeep Grand Cherokee

2 Answers

1996 jeep grand cherokee laredo: I had just bought this jeep from an owner and i locked the doors yesterday. When i went to unlock the door it set off the alarm. I have tried everything possible to...


put the key in the drivers door lock it with the key still in the lock unlock it and then pull the key out do this three times that is the factory built in security programing shut off system for jeeps and chrysler

Mar 11, 2011 | 1996 Jeep Grand Cherokee

1 Answer

I have a jeep grand cherokee laredo 1993, the security system have been activated and now when I start it, it will only stay started for a few seconds. tried turning the key all the way to the right and...


first use your remote, lock-unlock-lock-unlock 5 times. use the key to unlock the door. lock with remote. If this fails, disconnect battery for 5 min. reconnect, should reset control module..

Dec 09, 2010 | 1993 Jeep Grand Cherokee

1 Answer

How to disable the alarm system on a 1997 jeep grand cherokee laredo


i have a 1997 jeep grand cherekee laredo and am having a problem with the alarm its a factory alarm it whent off and i cant get it to reset i tryed everything i could locking and unlocking the doors i put all new fuses and relays in i even unpluged top dash alarm sensor and body control module and it just dont want to reset and it dont want to run at all how can i take care of the problem

Nov 25, 2010 | 1997 Jeep Grand Cherokee

1 Answer

1997 Jeep grand cherokee laredo with 4.0 starts and stops immediatley will not run. also horn blows like alarm has gone off


The VTSS (Vehicle Theft Security System) might be armed. To dissarm insert and rotate the key on the driver door lock or the passenger door lock or the liftgate door lock. You can also disarm it by pushing the button on the keyless control unit.

May 31, 2010 | 1997 Jeep Grand Cherokee

3 Answers

CAN YOU TELL ME HOW TO USE A SLIM JIM TO UNLOCK JEEP GRAND CHEROKEE LAREDO. LOCKED KEYS IN CAR.


a slim jim is not a good ideal to be using in todays cars and trucks with airbags everywhere and wires inside doors..call a pro and if he pulls out a slim jim send him packin...there a re far better tools to use than a slim jim

Oct 24, 2008 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...