Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Apr 03, 2019

2007 jeep wrangler dash lights blinking when jump started then stalls with no power at all.

Replaced battery and alternator and pops right off when jumped, but same thing-blinking dash lights and very rough running. Remove cables and dies with absolutely no power.

2 Answers

Jonah Oneal

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Jeep Master 14,092 Answers
  • Posted on Apr 03, 2019
Jonah Oneal
Jeep Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Mar 17, 2009
Answers
14092
Questions
0
Helped
7236534
Points
44533

Replace battery cables.check battery 150 amp fuse.

Wes Cameron

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 52 Answers
  • Posted on Apr 03, 2019
Wes Cameron
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Oct 01, 2012
Answers
52
Questions
0
Helped
13081
Points
120

Week. Check fuses. Be careful when jumpstarting. Sometimes it's easy to damage the computer on vehicles

Ad

5 Related Answers

Anonymous

  • 475 Answers
  • Posted on Nov 03, 2008

SOURCE: won't stay running 95 jeep grand cheerekee laredo 4x4

When you put the jumper cables on, put the key in the drivers door lock and unlock the door to deactivate the factory alarm.

Ad

Anonymous

  • 15 Answers
  • Posted on Nov 28, 2008

SOURCE: Jeep running rough; black smoke from tailpipe; dying occasionally

Have you taken a spark plug out yet? You may have fowled them out. if they are not clean and have a whitish tone to them, then they need to be replaced.

Anonymous

  • 1990 Answers
  • Posted on Jan 27, 2009

SOURCE: I HAVE A 94 JEEP

Check the Belt Tensioner. If the Tensioner is not Keeping the Belt Tight it will Drain the Battery Pretty Fast.Please Rate my Response, I need all the Help That I can Get! Thanks!

Philip Armitage

  • 437 Answers
  • Posted on Oct 21, 2011

SOURCE: Daughter called me ..car wont

it sounds like you have blown fuse to the Alternator.. I don't know what car you are talking about but they charging systems vary.. But if alternator isn't getting all the power it needs it won't charge. this should be checked.

good luck

Anonymous

  • 1 Answer
  • Posted on Jul 24, 2012

SOURCE: 94 Jeep Grand Cherokee will not start

just had this happen on same type of car
drove me crazy for DAYS.. FOUND IT WAS JUST AN ALTERNATOR FUSE.!!! UNDER BLACK BOX BEHIND THE BATTERY
FIVE BUCKS AT ANY AUTO STORE...
THIS WAS AFTER SPENDING 120 ON A NEW BATTERY....
THATS ALL IT IS

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 jeep wrangler won't start have power, but won't turn over hear a clicking in fuse box. any suggestions?

battery is dead.
check fuses, the clicking is the starter relay that is its job is to click.
but if it rattles that means low battery

what we do is a AAA jumper of battery, jump start battery with a donor car. if it starts now. then.
1: the battery was only discharged , so charge it.
2: or if it repeats the battery is bad. OR
3: if the voltage is not 13.3 to 15v running the alternator is shut down.

easy huh, just 3 checks.
0helpful
1answer
1helpful
2answers

I havent been having any problems but when I try to start my jeep,it's not turning over at all.I have lights..I had the battery checked at a Parts store and it's good.It won't boost off but I can push it...

You should have a switch on the clutch pedal under the dash. easy to test,,,just jump across it and see if it starts (only with trans in neutral and your foot on the clutch because it can start in gear when jumped) You also have a relay in the power distribution center and a fuse as well. Relay test is simple...most of the relays are the same so just swap positions. You should also check to make sure power is getting to the starter...12v at main connection and 12v at the small connection with the key turned to the start position (again in neutral and at least have the brake on) If you have power at the starter, likely it has failed. Don't forget...ignition switch needs to be working as well.
0helpful
1answer

Wont turn over

The starter is most likely the problem,tap on the starter lightly with a hammer while trying to start the engine,dont get run over doing this it will take two people,if the engine starts,the starter needs replacing.
0helpful
2answers

Jeep 2007 Wrangler Unlimited X 4x4 4 Doors

Sounds like a short in the electrical system. Maybe even just a loose ground wire. On the other hand...It could just as easily be a bad ECM (BRAIN)! Warranty still in tact? I hope so. Diagnostic at a certified Jeep shop... Good Luck!
0helpful
1answer

Today i notied my wipers were moving quite slow en

Check your alternator and charging system
0helpful
1answer

Jeep won't turn over

Check battery first. If battery is good, charge it and your vehicle should start, The symptons your having are indication of a bad charging circuit. When you start it leave the Negative battery loose enough to pull off after it is running, if it continues to run then it was a bad connection somewhere in the circuit or your regualtor, an internal part of the alternator is bad allowing the current to drain in you battery slowly over time when the engine is running. If battery checks good remove alternator and take to an autoparts store and have them check it. Generally most vehicles have a battery or charge light on the dash that will be lit.
0helpful
1answer

Starting/Alternator Gauge problems

It maybe as simple as corroded battery terminals. Somtimes they corrode between the post and the terminal itself.When you run light loads there is enough current passing through.When you crank the engine however,the large current flow will not pass. When you jump the car the clamps are biting on the outside of the terminal and current flows easy. Simply clean or replace the terminals and clean the posts as well to a silver shine and the trouble may go away
Not finding what you are looking for?

191 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...