Change the sensor wires on all 4 wheels antilock brakes should work
Thanks for info your the only one that had a solution
Use brake parts cleaner to clean all surfaces from brake dust metal shavings and debris just ensure everything is clean for sensors to get a clear signal a lot of people avoid this problem due to cost of sensors but it's well worth it for and to work properly it's your safety your talking about and you are welcome. Good luck
If that doesn't work it very well could be your end system itself but local junk yards might possibly have all your parts to save you some money
95 del sol civic check other year model 95 Honda's they should be interchangeable parts
×
Abs sensor might need to be cleaned
All 4 of the wheel hubs have a wire going to them. Either...
1... one of the wires is damaged or disconnected or..
2... someone did some hub work at one time and damaged a sensor.(cracked inside of hub)during replacement.
I would check the wires first. There should be electrical looking.. flexible.. rugged looking wiring that goes into each
Hub( back side where chasis/suspension meets the wheel area)
Power wash first...before inspecting. So dirt isn't covering anything
The abs brakes won’t work if there is a problem in the system. That is why the abs light is on. That being said...your normal hydraulic brakes will continue to work fine even with the abs light illuminated.
If it don’t work that is why the light is on
SOURCE: 1996 honda del sol abs light stays on
If the ABS light is on, you have either a failing ABS (wheelspeed) sensor, or a bad ABS control module. You'll need a diagnostic scan to find out which it is. As for the owner's manual, there are a number of online owner's forums that will probably have the manual or at least the same information posted, or you can search eBay for one - they're common finds there.
157 views
Usually answered in minutes!
×