What is the torque spec on the front wheel bearing 2001 saturn sl1?

SOURCE: Torque Spec

Front wheel bearing hub is 147 ft lbs. Axle nut is 170 ft lbs.

SOURCE: what are the front wheel bearing torque specs for

Hi there
i read your report. It 155 to 210 foot lbs. I recommend start off your lowest settings. I wouldn't any higher then 195 foot lbs. hope this info helps you.TY you for writing to fix ya.

Best Regards Richard

SOURCE: Torque specs for front wheel hub nut

112 to 174 ft lbs

SOURCE: 2005 SATURN VUE ABS, AWD, R/FRONT BEARING REPLACEMENT

just did one today. removed housing from car, and used a press . be careful of aluminum housing. also used penatrating spray. clean oxidation from inside bearing hole,then lubricating, helped in installation

SOURCE: what is the torque specs for a hub and bearing assembly on a 2001 four wheel drive chevy s10 blazer

Adjustment

The wheel bearings on these vehicles are not adjustable. If the bearings become loose or make noise, they must be replaced.

Removal & Installation

1. Before servicing the vehicle, refer to the Precautions section.
2. On 4WD vehicles, remove wheel center cap, if equipped, and the drive axle nut and washer
3. Raise and support the vehicle.
4. Remove or disconnect the following:
   NOTE Lay the hub and bearing on the wheel studs on the outboard side. This will avoid damaging the bearing seal.
   
   
   Tire and wheel Caliper, leaving the fluid lines connected Brake rotor Halfshaft from the hub and bearing on 4WD vehicles. Place a brass drift against the outer edge of the halfshaft to protect the shaft threads. Use a hammer to sharply strike the brass drift, but to do not remove the halfshaft at this time. Wheel speed sensor Wheel hub and bearing-to-steering knuckle bolts and hub and bearing
   
   
   Splash shield from the steering knuckle Seal from the hub and bearing
   

1. Install or connect the following:
   
   Wheel hub and bearing seal Splash shield to the steering knuckle, making sure it-s properly aligned Hub and bearing to the steering knuckle, aligning the threaded holes Hub and bearing bolts and tighten to 77 ft. lbs. (105 Nm) Wheel speed sensor. Tighten the bolt to 13 ft. lbs. (18 Nm). Rotor and brake caliper Tire and wheel
   The Hub Bearing Torque - Front
   
   If Torque Specs are not in the box we recommend youtorque to this setting. Axle Nut: 103 Ft/Lbs.Flange Bolts: 77 Ft/Lbs. WARNING: Failure to observe the following warningscould create a risk of death or serious injury.Proper maintenance and handling practices arecritical.Always follow installation instructions and maintainproper lubrication.Every reasonable effort has been made to ensure theaccuracy of the information contained in thiswriting, but no liability is accepted for errors,omissions or for any other reason.This information is not intended to substitute forthe specific recommendations of your vehiclemanufacturer.Always use the recommended torque requirement unlessotherwise specified in the carton.Depending on the application, type of hub unitbearing and location, the installation process mayvary.Please review the vehicle manufacturer'srecommendation before removing or installingcomponents.
   
2. Lower the vehicle
3. On 4WD vehicles, install the drive axle nut and tighten to 103 ft. lbs. (140 Nm), then install the center cap.