I have a 2000 dodge caravan . I need to replace the tcc solenoid can someone please tell me the exact location of this solenoid. The code it's throwing out is P0740. It's called at TE-4 control solenoid.

SOURCE: I need to find out where the shift solenoid is located on the tra

I've been having this problem with this car for a while.This is the third time which I needed to change the damn solenoid in 3 years.You need to take the whole air filter off,you have in the front two screws,and two more just to loose the clamps.You need to pull the whole thing out,once you take it out,you should be able to see it under two black hoses,it has 3 screws into it,it's very easy to take off and replace,about 2 hours total.No more domestic cars for me for as long as I live!Good luck!

SOURCE: 2000 Honda Accord Check Engine light on p0740

YOU HAVE A TORQUE CONVERTER PROBLEM. TORQUE CONVERTER CONTROL CIRCUIT MALFUNCTION CODES CAN COME FROM ELECTRICLE TO INTERNAL MALFUNCTION. IF YOU START EXPERIENCING A HARD SHIFT OR FREE SPIN TO HARD SHIFT DON'T BE SURPRISED. TRY CHANGING FLUID. THIS MAY HELP. HONDA WOULD HAVE REPLACED TRANS IF UNDER 105 k FOR FREE. IF YOU HAVE TO REPLACE TRANS. BUY ONE FROM HONDA, 3 YR WARRANTY AND AS CHEAP AS A REBUILT TRANS. HAVE A QUALIFIED PERSON INSTALL, YOU WILL SAVE ABOUT $500 DOING IT THIS WAY. GOOD LUCK

SOURCE: check engine reads P0740 honda civic

I am sorry to bum you guys out, but this usually means the piston in the torque converter is bad. The converter needs to be replaced along with a transmission flush.

SOURCE: how to test the tcc solenoid

P0740=Torque Converter Clutch Circuit/Open,
not a solenoid,or tps

SOURCE: trouble with the transmission solenoid

USUALLY A SHIFT SOLENOID DTC IS REPAIRED BY REPLACING THE TRANS SOLENOID PACK ASSEMBLY..LOCATED ON OUTSIDE OF TRANSMISSION..YOU MUST BE CAREFUL WHEN CHANGING PACK..CLEAN ALL DIRT/DEBRIS FROM OUTSIDE OF PACK..YOU DON'T WANT ANY DIRT TO ENTER TRANSMISSION..SOLENOID IS A SMALL BOX LOCATED ON SIDE OF TRANS FACING FRONT OF VEHICLE..YOU MUST REMOVE TRANS COOLER LINE HOSES FROM FITTINGS ON TRANS..REMOVE INPUT SPEED SENSOR..UNPLUG PACK..8MM SCREW HOLDS IT..3 BOLTS HOLD PACK TO TRANS..YOU MUST CLEAN ALL GASKET RESIDUE THOROUGHLY BEFORE INSTALLING PACK..I'D RECOMMEND GETTING SOMEONE WHO HAS DONE THIS BEFORE IF YOU ARE NOT COMFORTABLE DOING THIS..I HOPE THIS HELPS