What are the bolt torque specs for the front differential cover on a 2005 Jeep Wrangler?

The general torque spec is 25-30 ft-lbs for the cover bolts for a GM 10 bolt rear axle.

Bobby, oil pan bolt torques for 4.0 Wrangler. Oil Pan Bolts 1/4 84 in-lbs Oil Pan Bolts 5/16 132 in-lbs As far as sequence, see last link, start in center, criss cross pattern tighten snug all, then repeat to torque spec.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Oil Pan Gasket leaking
http://jeephorizons.com/tech/99_40l_torque_specs.html
98 jeep 4 0 oil pan bolt torque sequence specs Google Search

Torque Specifications

Description Nm lb-ft Axle-to-frame bolt 66 49 Axle damper-to-frame bolt 34 25 Brake caliper guide pin bolt 33 24 Differential bearing cap bolt 61 45 Differential housing cover bolt 29 21 Ring gear bolt 122 90 Tie-rod nut 91 67 U-joint spider retainer bolt 19 14 Upper ball joint pinch bolt 48 35

1 MIN IS CUTTING IT CLOSE BUT YOU SHOULD BE ABLE TO MAKE IT. TORQUE SPECS SHOULD BE 14 TO 15 FOOT LBS.

Suggest to remove cover and replace gasket with Permatex Gasket Maker Silicone. Fully clean and dry apply a 1/4 bead on cover and bolt down to 20 ft lbs. go around several times to compress silicone. Let silicone cure 30 minutes then refill.

timing belt? on a Jeep? 05 wrangler
what engine is this>?
ah the 2.4L
front cover

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove the crankshaft vibration damper.
3. Remove the generator drive belt tensioner assembly.
4. Remove the timing belt front cover bolts, and remove the covers.

rear cover

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove the front covers.
3. Remove the timing belt.
4. Hold the camshaft sprocket with Special Tool 6847, or equivalent, while removing the center bolt.
5. Remove the timing belt idler pulley.
6. Remove the rear cover fasteners and remove the cover from engine.

WELL THE DIFFERENTIAL COVER BOLTS TORQUE IS 30 FT LBS.

If the fluid does NOT meet the original fluid specs, then save up for new differential. Otherwise, you should be OK - double check it though. I have no idea what fluid you're thinking of using.

DIFFERENTIAL COVER BOLTS TORQUE IS 30 FT LBS.

I'm not sure, but there are thousands of Jeep forums on the web-I'm sure there are guys there that can tell you everything you need to know.