Well there are 2 choices.
read the jeep manual, gen2, service manual or
get the kit
https://www.scosche.com/car-audio/installation/harness
choice 1 butcher the wires
choice 2, nice.
SOURCE: wiring diagram
Try this link http://autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/15/3e/8f/0900823d80153e8f.jsp
SOURCE: Distributor cap wiring diagram
Check this info... Wiring Diagrams with the graphic firing order for 6 and 8 cilinders.
Good luck!!!
SOURCE: shift indicator light 1999 Jeep Grand Cherokee
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
SOURCE: Where is the speed sensor located on a 1999 Jeep
it is located right at the tail shaft of the transfer case where the rear drive shaft comes out.its the only sensor in that area.
1,410 views
Usually answered in minutes!
I have a green\red wire and a black\yellow wire and I can’t figure out what it’s for
×