-
Expert
52 Answers
- Posted on Aug 06, 2009
Re: I need to replace the alternator on my sisters car...
If you have the 2.3 liter engine follow these steps...
- On models with anti-theft audio system , refer to Technician Safety Information .
- Disconnect battery ground cable.
- Remove lefthand charge air cooler, then righthand upper seal board, Fig. 3 .
- Remove condenser fan assembly.
- Disconnect alternator, then alternator electrical connector.
- Remove lefthand splash shield.
- Remove drive belt.
- Remove A/C compressor, then, with pipe still connected, position A/C compressor away from generator for easy access to alternator.
- Remove alternator from under vehicle.
- Reverse procedure to install, noting the following:
- Torque lefthand splash shield bolts to 70 - 95 in.lb.
- Torque condenser fan bolts to 70 - 95 in.lb.
- Torque lefthand charge air cooler nuts to 12 - 16 ft.lb.
if you have the 2.5 liter engine then follow these steps....
- On models with anti-theft audio system , refer to Technician Safety Information for system deactivation procedure.
- Disconnect battery ground cable, then remove electrical harness, Fig. 4 .
- Disconnect terminal B wire, then alternator electrical connector.
- Remove righthand splash shield.
- Remove drive belt.
- Remove A/C compressor; then, with pipe still connected, position A/C compressor away from generator for easy access to alternator.
- Remove alternator from under vehicle.
- Reverse procedure to install, noting the following:
- Torque upper alternator bolt to 12 - 16 ft.lb., then lower alternator bolt to 24 - 33 ft.lb., Fig. 4 .
- Torque A/C compressor bolts to 12 - 16 ft.lb.
- Torque righthand splash shield bolts to 70 - 95 in.lb.
×