It a very loud sound if take my foot off the gas pedal the sound begin but if i press the gas again it goes away
SOURCE: 2002 tahoe breaks lock up during driving
i would check front and rear brakes if rears are drum brakes i would inspect springs and hardware making sure everthing is conected and in place also make sure they are adjusted properly in the front and if rear disc i would make sure to grease caliper slides these allow caliper to move and its important that all moving brake parts are free push caliper pistons in alittle to see if they are sized or not booster is ok and most of the time when master goes it will leak where it meets booster and you will have a low brake pedal or no brakes
SOURCE: grinding sound when I break and after I break. It
may just be worn brake pads that are matel to metal.remove the calipers and use a c clamp to push piston in,if its hard to push piston then you may have a bad caliper,if its hard try opening bleeder screw if it gets easy to push then you have a bad brake hose on that side, also clen and lube the caliper slides and braket were pads set, hope this helps.
SOURCE: breaks will not work at random times?
hi this sounds like you have air in your system and either something is leaking and letting in air but if you have changed the pads did you make sure the lid was off the fluid bottle was taken off as pushing the pistons back in to the callipers can cause the seals on the master cylinder or slave cylinder could be at fault with air in the system if you pump the brakes they will for a bit then this is air, if you pump up the brakes , when it goes hard just keep presure on it then let off your foot slightly then press hard again and it dips but stays hard and you do the same till it hits the floor this is also air but not leaking just air in system the first bit will be something leaking...hope this helps
SOURCE: My bobbin thread keeps breaking
rethread the machine top & bobbin
change needles
make sure the needle is inserted correctly
check the top thread tension--3 or 4 usually is good
some needles & thread do not work togeather-try this
Cut 6-8 inch piece of thread of the spool you are going to use for your project
Take the needle you are going to use for the project
& insert the thread thru the eye of the needle
& lift one end of the thread to a 45 degree angle
& if the needle is the right size for the thread it will slide down the thread
But if the needle hangs on the thread you need one size larger needle for the thread
if none of these suggestions work then you should consider taking it to a repair shop to be checked
SOURCE: 2002 Kia Sportage break tighening up where break pedal is hard to press down
Hello...get the vehicle back to the shop that worked on it....Sounds to me like one or more of the calipers won't release it's grip when you release the brake pedal or the master cylinder is locked...Think about it...it's like driving with your foot on the brake pedal....or maybe your power brake booster...anyway...Get it back to the shop that worked on it and bring your receipts for all the work done...Let me know what happens...I hope this was helpful...PEACE........
36 views
Usually answered in minutes!
×