You just go to the link below, I'm sure you will get the solution of the problem
https://www.reliable-store.com
SOURCE: 2004 Chevy Tahoe stereo wiring diagram
BLACK-ground
RED-accessorie
YELLOW-power 12v
PURPLE-left rear
GREEN-right rear
WHITE-left front
GREY-right front
BLUE-REMOTE
and the other blue one is for remote antenna..
SOURCE: 1996 tahoe tranny not shifting
The L60E Tranny's were not Covered under this Recall. Therefore, You should be Just fine with a Cleaning and Reassemby. Just to be Absolutely sure, Check Edmonds.com and Enter your Trucks Make year and Model and it will give you the Recalls, Complaints and Service Bulletins for your Truck. Please Rate My Response! Thanks!
SOURCE: 1988 Chevy truck
no try looking at the governer on the back should be a cover about 4 in arond remove and look to see if the plastic teeth are broken or worn.
SOURCE: program a new key fob for a 2002 chevy tahoe
1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold
down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the
engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock
the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
the door locks and unlocks.
This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any existing
transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming
mode.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: 2002 chevy hd duramax 4x4
Sounds like the PRNDL switch on the side of the transmission. Be sure and clear the code before trying to start after replacing it.
72 views
Usually answered in minutes!
×