Bought 93 Toyota fwd pu to use off road only but the wiring has been burned s and it has started but will do nothing but idle. I would just like to see what needs to be wired to run thank you

Maybe faulty ignition switch or relay

How long has it been since it had a new fuel filter? Hard to diagnose with given information, but a cheap place to start.

Bad circuit board tail light asseblise connector pin to board poor connection or burned push in light bulb sockets
On my '93 Chevy PU the new ones went bad within months I repaired the original ones by soldering all connector pins to the board cleaned the sockets chipping out melted plastic been working for five years now.
Care must be taken to keep solder from preventing wire connector install while using enough that plugging it in will not break these delicate unions.
Required pulling them several times to Finnish repair successfully.
Very disappointed in replacement parts.

Toyota Previa Questions - 93 toyota previa having white ...

www.cargurus.com > Questions > Toyota > Previa

CarGurusMar 17, 2013 - 93 toyota previa having white smoke while starting and stu-off while running on the road. ... Lift the cylinder head off the engine block and move to oneside. Remove the ... 1992 Toyota Previa 3 Dr LE Passenger Van ... was going down the road one day and it just shut off. it will turn over but wont crank.Missing: water

Rough idle, bad hesitation on acceleration, perfect idle with ...

repairpal.com > Questions > Toyota > Previa > 1994 Toyota Previa

1994 Toyota Previa Questions ... Idle is perfectly smooth for first 1 - 2 minutes after overnight cold start, before .... This may be because the throttle position sensor is signalling just off idle. .... My check engine light came on with PO-420 code. ... theengine was turning over under starter motor that would bring the engine to an ...

Re: Replacing a Previa head gasket. - ToyotaVanTech

www.toyotavantech.com > Forum > Technical Discussion > Toyota Previas

Dec 3, 2011 - 20 posts - ‎2 authors
Okay, so you've got a Toyota Previa with a blown head gasket. ... The next few pix are taken after dropping the engine out from the bottom using a ... You can see a definite path between the water jacket and the cylinder. ... I believe this was a result of #1blowing and over pressurizing the cooling system.

How to Change a Coolant Temperature Sensor - YouTube

? 26:00
https://www.youtube.com/watch?v=IXSp5ykI6po
Sep 16, 2012 - Uploaded by rehma6b0

check you have knot knocked the wire off the distributor ignition light will not come on if its off..

Well, you have to take off the dashboard before you can do anything. Hope this helps?!



Please rate and comment - Thank You

try using thicker oil sounds like it has much engine wear and the thin oil is just slipping by the rings and burning with the fuel.also check your pcv valve if its bad it will allow engine to **** in oil and burn it with combustion.

i am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount?

I would check the fuel pump relay under the dash in the passenger side and check the efi relay first. After that i would follow the wires to the fuel pump and the engine harness for any shorts.

usually the cam bearings or main bearings are worn